1. ob2000.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (ob2000.zip)

                                                                      
                                                                      
HP OMNIBOOK 2000/5700 NOTEBOOK PC - WINDOWS 3.1 OR WINDOWS FOR WORKGROUPS
3.11, INSTALLING CD-ROM DRIVERS


INTRODUCTION
     
     The HP OmniBook 2000/5700 Notebook PC includes Microsoft (R) Windows
     for Workgroups 3.11 as one choice for the preloaded and preconfigured
     operating system.  If installing retail Windows for Workgroups 3.11 
     or Windows 3.1, follow these instructions to install the OmniBook 
     CD-ROM drivers for the OmniBook CD-ROM drive.

REQUIREMENTS
     
     *    HP OmniBook 2000/5700 Notebook PC with Microsoft Windows 3.1 or
          Windows for Workgroups 3.11 installed. 
     
     *    HP OmniBook 2000/5700 Notebook PC CD-ROM drivers.  Obtain the drivers
          from the hard disk in the C:\OMNIBOOK\DRIVERS\WFW\CDROM directory or
          from the HP OmniBook 2000/5700 Notebook PC Recovery CD in the 
          \OMNIBOOK\DRIVERS\WFW\CDROM directory. 

PROCEDURE
     
     1.   Exit Windows.
     
     2.   At the MS-DOS command prompt, go to the directory that
          contains the CD-ROM drivers. For example, on the hard disk type
          
               C:
          
               CD \OMNIBOOK\DRIVERS\WFW\CDROM
     
     3.   Start the installation by typing
          
               TOSH
     
          Then follow the prompts.  Select the default choices, but
          read them carefully.  HP recommends installing all files into
          C:\CDROM.  Allow the install program to change the CONFIG.SYS
          and AUTOEXEC.BAT files.
     
     4.   Remove the Support Utility disk, then press CTRL+ALT+DEL to
          reboot the HP OmniBook Notebook PC.  The internal CD-ROM is
          then ready for use.
     
     The following lines from CONFIG.SYS and AUTOEXEC.BAT are the
     standard HP OmniBook Notebook PC entries:
     
          CONFIG.SYS
          
               REM Enable HP OmniBook Notebook PC internal CD-ROM driver...
          
               device=c:\cdrom\d011v200.sys /d:mscd001 /n:1 /s:170,15,0
     
          AUTOEXEC.BAT
          
               c:\dos\mscdex.exe /d:mscd001

______________________________________________________________________
               Windows (R) and MS Windows (R) are U. S.
               registered trademarks of Microsoft Corp.
                                   
             MS-DOS (R) is a U.S. registered trademark of
                        Microsoft Corporation.
                                   
            Microsoft (R) is a U.S. registered trademark of
                            Microsoft Corp.
                                   
                  Copyright  Hewlett-Packard Co. 1997
       This information is subject to change without notice and
                 is provided "as is" with no warranty.
          Hewlett-Packard shall not be liable for any direct,
        indirect, special, incidental or consequential damages
             in connection with the use of this material.