1. DE660.EXE Driver
2. DLKTCP.TXT File Contents

DLKTCP.TXT Driver File Contents (DE660.EXE)

==================================================================
NOTES ON
Installing D-Link DE-660 Ethernet PC Card
For D-Link's TCP/IP Users
==================================================================
    (c) 1997 Copyright D-Link Corporation  ALL RIGHTS RESERVED

This document contains installation notes, which is not included in the
DE-660 Ethernet PC Card USER'S GUIDE or onscreen instructions,
for D-Link's TCP/IP users regarding DE-660 Ethernet PC Card installation.

( Please note the "D-Link's TCP/IP" is the TCP/IP program
                       which has been modified by D-Link.)


This document contains information on the following topics:

1.0 Introduction
2.0 Installing Packet driver
___________________________________________________________________


1.0 Introduction
----------------

D-Link's TCP/IP users please also refer to the following:

    -------------------------------------------------------------------
     File                  Description/Installation notes
    -------------------------------------------------------------------
      \README.TXT            For all users

      \PKTDRV\README.TXT     For all Packet driver users


2.0   Installing Packet Driver
------------------------------

There are two methods to run the D-Link's TCP/IP program.

    METHOD 1:

    In your CONFIG.SYS file, include the DEVICE command.

         Format:
         DEVICE = DE660PD.SYS [/option] <packet_int_no>

             <packet_int_no> is the software interrupt vector number
                             used by the packet driver program.
                             This can be from 96 to 128.
             /d              Delay Initial - The driver program will not
                             initialize the network interface card until
                             the packet driver program is accessed by
                             its upper layer program.

             /w              The -w parameter is for use only in Windows
                             environment.


    METHOD 2:
    1. In your AUTOEXEC.BAT file, include the following command line:

         Format:
         set HOSTS=<PATH>

         <PATH> is the directory where the D-Link TCP/IP programs reside.

    2. Issue DE660PD command at the DOS command prompt:

         Format:
         DE660PD [/option] <packet_int_no>

    3. Run TCPSTART.EXE, at the DOS command prompt, to start TCP/IP.


Please also refer to the INST_DOS.TXT for more information.