1. ob800mmx.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (ob800mmx.zip)

                  Installing mouse support



System Installation Requirements

HP OmniBook 800 installed with Windows 3.1 or Windows for Workgroups

HP OmniBook 800 Mouse Drivers.  These drivers are located on the OmniBook hard
   disk in C:\OMNIBOOK\DRIVERS\WFW\MOUSE. These drivers are also located on
   the HP OmniBook Recovery CD in the \OmniBook\DRIVERS\WFW\MOUSE directory.


Procedure

1.  Create a directory named C:\MOUSE.

2.  Add the following line to the C:\AUTOEXEC.BAT file:

          set mouse=c:\mouse

3.  Add c:\mouse to the path statement in the C:\AUTOEXEC.BAT file.

          (e.g. path=c:\;c:\windows;c:\dos;c:\mouse)

4.  Add c:\mouse\obamc16.exe to the run statement in the C:\WINDOWS\WIN.INI
    file:

          (e.g. run=c:\mouse\obamc16.exe)
          
5.  Copy the files from C:\OMNIBOOK\DRIVERS\WFW\MOUSE\MOUSE directory to the
    newly created C:\MOUSE directory.

6.  Reboot the OmniBook.


The MOUSE.INI file should look as follows:

[mouse]
MouseType=PS2
ActiveAccelerationProfile=4

[AccelerationProfile1]
Label=Slow
Movement=1    5    7   9    11   37   39   41   43
Factor=1.00 1.25 1.50 1.75 2.00 2.25 2.50 2.75 3.00

[AccelerationProfile2]
Label=Moderate
Movement=1    9   12   15   18   21   24   27   30   33   37
          41   46
Factor=1.00 1.25 1.50 1.75 2.00 2.25 2.50 2.75 3.00 3.25
          3.50 3.75 4.00

[AccelerationProfile3]
Label=Fast
Movement=1    2    3    4    5    7    9   11   13   16   19
22   25   28   31   35   39   43   48   53   60
Factor=1.00 1.25 1.50 1.75 2.00 2.25 2.50 2.75 3.00 3.25
3.50 3.75 4.00 4.25 4.50 4.75 5.00 5.25 5.50 5.75 6.00

[AccelerationProfile4]
Label=Unaccelerated
Movement=1
Factor=1.00

[AccelerationProfile5]
Label=Unaccelerated
Movement=1
Factor=2.00



Connecting a serial mouse

To activate a serial mouse connected to the OmniBook or the Docking System,
you must change the mouse type in Windows Setup.

1.  Open the Windows Setup icon in Program Manager, change the mouse type to
    Mouse System Serial.

2.  Restart Windows. (If prompted for the mouse driver, type the C:\MASTERS.
    This will be the path suggested in the dialog box.  If the software is
    NOT the default Hewlett-Packard load, type A:\ and insert the requested
    Windows for Workgroups installation floppy disk.)

3.  To reactivate the built-in mouse, use Windows Setup to change the mouse
    type to Microsoft Or IBM PS/2.