1. 245030.exe Driver
2. NETWAR40.TXT File Contents

NETWAR40.TXT Driver File Contents (245030.exe)

Novell NetWare 4.x server
This is an ASCII file called NETWAR40.TXT in the ATI 
CardAssistant INFO directory. Use a text editor or a 
word processor with a mono-space font such as Courier 
to print this file if needed for reference.
************************************************************
************************************************************
**                                                        **
**         Novell NetWare 4.x Server Installation         **
**                                                        **
************************************************************
************************************************************

------------------------------------------------------------
--                          Contents                      --
------------------------------------------------------------
I.   Special Considerations 
II.  Installing the AT-2450: New Server Installation 
III. Manual Installation 

I.  Special Considerations
==========================

From a DOS prompt, run the SETUP24 utility if necessary to 
manually view the card's configuration, or to configure the 
media or duplex mode, or to run Diagnostics. See manual for 
details. 

To de-install the driver, start NetWare and consult the 
NetWare documentation.


II. Installing the AT-2450: New Server Installation
===================================================

1. Follow the directions provided by Novell to install the 
   server files to a DOS partition on your server hard 
   drive.

2. When the Install program prompts for the LAN driver, 
   press <Insert> to specify a driver not listed.  Insert 
   the AT-2450 CardAssistant diskette into a drive and 
   press <F3> to change the default path to A:\NWSERVER. 
   Press <Enter> as prompted. The AT2450.LAN and other 
   required files will be copied to the SYS: volume.

3. On the next menu, "Driver 2450 Parameters", specify a 
   node address (NET= on the bind command line).

4. Select the desired Ethernet frame types. The default is 
   "802.2 and 802.3".

5. Proceed with the installation as outlined by Novell.

III. Manual Installation
========================

1. At the file server console prompt, type:

    LOAD <DRIVE>:\<DIRECTORY>\AT2450

   The default frame type is ETHERNET_802.2. If you wish 
   you use another, specify "FRAME=" on the command line.

   To load multiple frame types for a single card, the 
   command line option BOARD = n should be added,

   where n is the arbitrary board number, e.g., 1 or 2, 
   etc.

   Example: 
   LOAD C:\SERVER.312\AT2450 FRAME=ETHERNET_802.3 BOARD=1

   Also: If you have a PCI-1 bus in your system, add 
   BUSTYPE=PCI1 to the command line, i.e. 
   LOAD <DRIVE>:\<DIRECTORY>\AT2450 BUSTYPE=PCI1.
   Otherwise the driver may not find the card. If you don't 
   know which bus you have, try loading without the option. 
   If it loads, you don't need it.

2. Next you must bind the LAN driver to IPX in order to 
   attach to the server. Type:

    BIND IPX TO AT2450 NET=n

   where n is the node address for Novell uses for routing 
   IPX packets.

Here's an example of how the commands would look in your 
AUTOEXEC.NCF file. ("NCF Files Options - Create / Edit 
Server Startup Files")

  LOAD AT2450 FRAME=Ethernet_802.3 (overrides default frame 
                                    type)
  BIND IPX to AT2450 net=1         (all servers on the LAN 
                                    need the same #)

Any other parameters are independent of the configuration 
of the AT-2450, and they are described in detail in 
Novell's documentation.

**END**