Tioman for HP v3.10.05 USING TIOMAN You will notice that once Tioman is installed on your system, a small icon will be displayed in the lower right hand corner of the taskbar whenever the computer is running. This taskbar icon is your gateway into the capabilities of Tioman. The icon will give a visual cue for the currently inserted device. You will immediately notice whether you currently have a floppy or CD-ROM drive, or even no device in the bay. Hovering over the icon will also display information on your currently inserted drive. Clicking on the icon will display the Tioman menu. This offers menu items for swapping devices, getting help, as well as more information on the Tioman software. NOTES Windows 98 is currently supported. Do not install the software on a Windows NT system, or Winows 95 OSR1. Always make sure the power is off to the device you are removing before physically removing it. KNOWN PROBLEMS Sometimes you must select 'Both Primary and Secondary enabled' for the IDE controller settings. Otherwise you will see failures to detect devices when inserted. If you cancel an uninstall, the taskbar icon is removed. You must restart your system to reenable the icon. You may experience device detection problems when docking or undocking your notebook. Certain applications that open files on a swappable device may not be detected when selecting Swap Device. You may experience errors or even system crashes if you remove a device in this case. Please make sure that all applications and windows are closed for a device you wish to remove. Swapping of INT13 devices is not supported. If you boot the system with a hard disk in the bay, your BIOS will detect the drive and Windows 95 will configure it as an INT13 hard disk drive. To avoid this, enter your BIOS setup and change the setting for Secondary Master from Auto detection to None. Once Windows is running, you can turn off the INT13 setting for the hard disk drive in Device Manager using the System icon under Control Panel. This procedure may also apply to the LS120. We recommend that you immediately remove a device after performing a Remove Device command. Changing from one device to another device while the system is suspended (Warm Swapping) is supported but some devices such as the LS120 are not supported in this release. We recommend Hot Swapping whenever possible. Changing diskette media during power suspend is not detected by Windows. Tioman's detection of diskette drives causes the loss of the media change indication. In these cases the contents of the previous diskette will still be displayed. You can force the system to recognize the new diskette by ejecting and reinserting the diskette media. Note: There is currently an incompatibility between the Agate hot swap software and Windows 98 with DvD; when the notebook boots, and there is no media in the DvD drive, the notebook will hang. For the latest fixes and updates, check our website at: http://www.hp.com/omnibook.Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.