---------------------------------------------------------------------------- INSTALLATION INSTRUCTIONS OS/2 V3.0 (WARP) NOTE: The Installation Diskette Volume Label must be "MAGIC 1". Please use the diskcopy utility if a backup diskette is made. NOTE: This procedure assumes you are installing from A: to C: If this is not the case make appropriate adjustments. 1. Open OS/2 SYSTEM. 2. Open COMMAND PROMPTS. 3. Open an OS/2 WINDOW or OS/2 FULL SCREEN command session. 4. Insert the NeoMagic Installation diskette in drive A. 5. From the OS/2 session type "A: [enter]". Then from the A: prompt type "setup c" [enter] 6. From the DISPLAY DRIVER INSTALL window, select PRIMARY DISPLAY select OK. 7. From the PRIMARY DISPLAY DRIVER LIST window, select NeoMagic NM2070 select OK. 8. From the SOURCE DIRECTORY window, make sure source directory points to location of installation diskette (use Change radio button to select the proper drive, if necessary) select INSTALL 9. After installation is complete, from the DISPLAY DRIVER INSTALL pop-up window, select OK 10. Remove the diskette from drive A. 11. Shut down by selecting the Shut down button on the Launch Pad, and re-boot. 12. If you want to change screen resolution then proceed with the appropriate Screen Resolution Modification instructions below. (defaults to 640 x 480) You may also reference installation instructions in the OS/2 Version 3.0 Installation guide. ---------------------------------------------------------------------------- OS/2 3.0 (Warp) Resolution Modification To change resolutions and pixel depths within the driver AFTER INSTALLATION, take the following steps: 1. Click your right mouse button on the OS/2 Desktop and select the entry "System Setup". When the folder opens, double click on the SYSTEM icon. 2. Select the Screen Resolution from among those listed, then close the System Settings Window by double clicking on the top-left corner. (NOTE: you must shut-down using the Shut down radio button on the Launch pad, and re-boot before the change will actually take place)Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.