1. L10C20.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (L10C20.zip)

                  Installing the PCMCIA Ethernet Card Driver
                               Under PathWorks
                 ============================================

     The NDIS2 driver for DOS program follows Microsoft's NDIS
     specification version 2.0.1.

     The PCMCIA Ethernet adapter driver program for Pathworks contained in
     this directory are as follows:

     Files            Contents
     -------------    ------------------------------------------------------
     PCMND.DOS        NDIS2 driver for PathWorks.
     PROTOCOL.INI     Includes driver binding information and operational
                      parameters.
     OEMSETUP._31     Network information for install file.
     \DISK1           For OEMSETUP._31.

     For more information about setting up the networking system driver,
     please see your DECnet Pathworks documentation.


     ***********************************
     *  Installation Procedures Steps  *
     ***********************************

     The PathWorks provide utility programs for installing drivers.

     This installation diskette supports for these utility programs, FOR
     THE FIRST BOARD INSTALLED ONLY.  If multiple boards are installed, the
     second and subsequent boards must be installed manually.

     1. Basic driver installation:

        . Add the following line to CONFIG.SYS.

           DEVICE=<drive>:\[pathname]\PCMND.DOS (or PCMND.OS2)

        . If the driver is installed in DOS HIGH memory using
          the following command line.

           DEVICEHIGH=<drive>:\[pathname]\PCMND.DOS

        . The following information is displayed when the system is
          rebooted.

     2. Installation with PATHWORKS for DOS Version 4.1

        A. Automatic Installation for DOS Pathworks use the NETSETUP
           Utility:

           If you install PATHWORKS for the first time or update it use
           installation program NETSETUP that respond the following prompts:

           . Select your desired choices for...
               Type of configuration.
               Destination Drive.(boot device)
               LK250 Keyboard setup information.

           . Select <Ethernet> network adapter type.

           . Select <Other NDIS> Ethernet adapter.

           . For full path for NDIS driver, enter

               A:\NDIS2\PATHWORK\PCMND.DOS

           . For full path for the PROTOCOL.INI file, enter

               A:\NDIS2\PATHWORK\

           The files are copied from this installation kit to its directory.

           Note: If PATHWORKS is updated using the NETSETUP installation
                 program, it is suggested to copy your old copy the
                 CONFIG.SYS and PROTOCOL.INI files before starting
                 NETSETUP.

        B. Manual installation for DOS Pathworks:

           . Copy the PCMND.DOS file from this installation kit to the
             PATHWORKS directory.

               For example:
               COPY A:\NDIS2\PATHWORK\PCMND.DOS <driver>:\pathname

           . Add the following line to your CONFIG.SYS to load the driver:

               DEVICE=<drive>:\pathname\PCMND.DOS

           . Append the following two lines to the end of the PROTOCOL.INI
             file.

               [PCMND.DOS]
               DRIVERNAME=PCMND$

           . Modify the DATALINK and IPX4MAC sections of your PROTOCOL.INI
             file.

               Change the value of the BINDINGS keyword.

                from BINDINGS = driverlabel
                  to BINDINGS = PCMND.DOS

           Notice: The Pathworks scheduler (SCHK) must be started with the
                   switch /N.
                   If /N is not used, initialization may fail with the
                   following message:

                      "No NIS Interrupt Activity. Maybe NI_IRQ set wrong or
                       cable not attached or hardware/DLL broken"