ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
³ ³
10/100 MB Ethernet Adapter Installation ³
³ ³
³ for the Windows 95 Driver ³
³ ³
ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
1) Content
ÄÄÄÄÄÄÄ
* Introduction
* System Requirement
* Installing Software
* Parameters
2) Introduction
ÄÄÄÄÄÄÄÄÄÄÄÄ
This file explains how to install the Windows 95 Driver.
3) System Requirement
ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
A) Hardware Requirements :
o An IBM-compatible personal computer with 80386 or higher
microprocessor and a PCI bus.
o This adapter.
B) Firmware Requirements :
o Fully compliant Rev. 2.0 or above PCI BIOS supplied with
the PC.
o If the adapter makes use of Digital Semiconductor 21050
(PCI-PCI bridge), PCI BIOS should support PCI-PCI bridge
architecture.
C) Software Revision Requirements :
Windows 95
4) Installing Software
ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
The Windows 95 is the operating system with Plug & Play feature.
A) Plug the adapter into the PCI slot of the PC.
B) After power on, the windows 95 will detect this new adapter,
then install the corresponding driver for it.
When the Windows 95 detected the new drivers has been within,
it will prompt user to keep the new driver or not. User should
choose "Yes".
C) When installation completely, Windows 95 will prompt user to
restart. After reboot, the new adapter will work fine.
5) Parameters
ÄÄÄÄÄÄÄÄÄÄ
ConnectionType:
o AutoSense auto-sense the media type
o 100BaseTx Set to 100Base-Tx mode
o 100BaseTx Full_Duplex Set to 100Base-Tx Full Duplex mode
o 10BaseT Set to 10Base-T mode
o 10BaseT Full_Duplex Set to 10BaseT Full Duplex mode
ReceiveBuffers = {8..64} (default: 16)
Number of buffers allocated by the
driver in the Receive ring.
MapRegisters = {4,8,16} (default: 8)
Number of map registers allocated
by the adapter.
BurstLength =
CSR0<PBL> 1 doubleword
2 doublewords
4 doublewords
8 doublewords
16 doublewords (default)
32 doublewords (DC21140 only)
StoreAndForward =
Select the StoreAndForward mode if high
PCI latencies causes Transmit Underruns
CSR6<SF> 1 Enabled
0 Disabled (default)
TransmitThreshold =
CSR6<TTM,TR> 72 bytes
96 bytes (DC2104X's default)
128 bytes
160 bytes
256 bytes (DC21140 only)
512 bytes (DC21140's default)
1024 bytes (DC21140 only)
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.