1. RP1651WWINBOND.zip Driver
2. SETUP.TXT File Contents

SETUP.TXT Driver File Contents (RP1651WWINBOND.zip)

*****************************************************************************
*                                                                           *
*                  RP-1651W 10Mbps PCI Ethernet Adapter V.2                 *
*                                                                           *
*                   Setup and Diagnostics Program Overview                  *
*                                                                           *
*****************************************************************************

A) Configure the Adapter:
   ======================
   1. Show Configuration Registers

      (a) Mode configuration registers

            Physical layer interface
            Link status
            link Test pulse
            SRAM select
            boot ROM size

      (b) PCI configuration

            Vendor ID register
            Device ID register
            Command register
            Status register
            Revision ID register
            cLass code register
            cache line siZe
            latency Timer
            header tYpe register
            BIST register
            I/o base register
            ROM base register
            iNterrupt line register
            interrupt Pin register
            Min-gnt register
            mAx-lat register

   2. Set Configuration Registers

      Mode configuration

            Physical layer interface
            link Test pulse
            SRAM select
            boot ROM size


B) Diagnose:
   =========
            Reset Test
            Register Test
            Remote DMA Test
            Loopback All Test
            Loopback 1 Test
            Loopback 2 Test
            Loopback 3 Test


C) Transmit/Receive Packet:
   ========================
   Check communication over the network cable.

            Transmit Packets
            Receive Packets
            Transceive


D) Show Physical Address:
   ======================
   To show the LAN Adapter physical address


E) Reset Adapter:
   ==============
   Excute this item and the controller chip will be reset.


Note:
   1. Before exiting this program, SETUP will ask users whether to select
      Frame Type in NET.CFG. If the multiple adapters exist, all information
      will be generated in NET.CFG file. Write-protected diskette can not be
      written for the file to be generated.

   2. (1) SETUP.EXE, (2)data.dat, (3)runtsize.pkt, (4)minisize.pkt,
      (5) maxisize.pkt,(6)onepage.pkt
      6 files should exist in the local hard disk.