1. ts018_1.exe Driver
2. 123INST.TXT File Contents

123INST.TXT Driver File Contents (ts018_1.exe)

              Installing the Graphics Accelerator VGA Drivers
                             for Lotus 1-2-3.


      In order to install these graphics and text drivers for Lotus 1-2-3:

      1) Install Lotus onto your hard disk as described in the 
	 doucmentation included with Lotus.  When prompted for the 
	 screen type, use 16 color VGA.

      2) Goto the subdirectory where Lotus is installed.

              Example:  C:\>cd \123

      3) Insert the Graphics Accelerator VGA Utility & Driver Disk into                 drive A and close the door.

      4) Run the installation file 123INST.BAT on drive A.

  	      Example:  C:\123>a:123inst

      5) Run the Lotus 1-2-3 install program.

	      Example:  C:\123>install

      5a) You will be presented with several menu choices.  Just follow
	  the directions on the screen and do the following in this order:

	      - Press <Enter> to begin.
	      - Choose the "Advanced Options" item.
	      - Choose the "Add New Drivers to the Library" item.
	      - Press <Enter> to proceed.
	      - Press <Enter> again to return to the menu.
	      - Choose the "Modify Current Driver Set" item.
	
      5b) You will now be presented with a list of settings.  To change an 
	  item, highlight it and you will be given a list of choices for                 that entry. Eight new drivers have been added to support the 
	  Graphics Accelerator VGA, six graphics drivers and two text                    drivers. There are two graphics drivers (dual and single screen)               for each resolution supported by Graphics Accelerator VGA                      (1024x768 and 800x600). Select "Graphics Driver" and choose either             dual or single screen Graphics Accelerator VGA for the highest                 resolution your display will support. Now select "Text Driver" and             choose from the Graphics Accelerator VGA text drivers. When your               configuration is correct, press <Esc> to return to the menu.  

      5c) Now, exit the installation program by doing the following:

	      - Choose the "Save Changes" item.
	      - Press <Enter> to accept the current set name.
	      - Press <Enter> again to return to the menu.
	      - Choose the "Yes" item to leave the install program.

      6) Run Lotus 1-2-3 as before.

	      Example:  C:\123>lotus