1. ts013_3.exe Driver
2. README.TXT File Contents

README.TXT Driver File Contents (ts013_3.exe)

03/23/94

This diskette contains release version 1.00 of the Diamond Stealth 32,
ET4000/W32i and ET4000/W32p display driver for OS/2 2.1.



                            
                   INSTALLATION  INSTRUCTIONS OS/2 V2.1

NOTE:  The Installation Diskette Volume Label must be OS-2.  Please
use the Diskcopy utility if a backup diskette is made.

1.      Open OS/2 SYSTEM.
2.      Open COMMAND PROMPTS.
3.      Open either OS/2 WINDOW or OS/2 FULL SCREEN.
4.      Insert Stealth 32 Installation diskette in drive A.
---------------------------------------------------------
|IF YOU HAVE A GATEWAY COMPUTER:
|        Type:
|            A: [enter]
|            GATEWAY A: C: [enter]
|
|            Where A: is the drive with the Stealth 32 Installation diskette,
|            and C: is the drive with OS/2 installed.
|
|            Now remove the Stealth 32 Installation diskette from drive A:,
|            Shut Down your system, reboot your computer, follow 
|            steps 1-4 again and continue with step 5 below.
---------------------------------------------------------
5.      Type:
                A: [enter]
                INSTALL A: C: [enter]

        Where A: is the drive with the Stealth 32 Installation diskette,
        and C: is the drive with OS/2 installed.

6.      From the DISPLAY DRIVER INSTALL window,
                select PRIMARY DISPLAY
                select OK.

7.      From the PRIMARY DISPLAY ADAPTER TYPE window,
                select Diamond Computer Systems - Stealth 32
                select OK.

8.      From the MONITOR CONFIGURATION/SELECTION UTILITY window,
                select INSTALL USING DISPLAY ADAPTER UTILITY PROGRAM
                select OK.

9.      From the MONITOR CONFIGURATION/SELECTION UTILITY LOCATION      
        window,
                type A:\SETMODE.EXE
                select OK
                
10.     SETMODE will prompt you to set refresh rates for 640x480
        resolution, then for 800x600, and finally for 1024x768. 
        Currently available choices are shown in parentheses.
        The refresh rates selected will apply to OS2 DESKTOP and
        seamless windows.
        

11.     From the SELECT DISPLAY RESOLUTION window,
                select the desired resolution
                select OK.

12.     From the SOURCE DIRECTORY window,
                select INSTALL.

13.     When the drivers are completely installed, you will be prompted 
         to shut down and restart the system for changes to take effect.
                select OK.

14.     Remove the diskette from drive A.
15.     Shut down and restart.

You may also reference installation instructions in the OS/2 Version 2.1 
Installation guide. 

     



                WIN-OS2 FULL SCREEN REFRESH RATES

To set a up WIN-OS2 Full screen refresh rates do the following:

1. Copy setmode.exe from the os2 driver disk to your
   utilities directory.
   e.g. copy A:\Setmode.exe C:\UTIL\Setmode.exe

2. Run Setmode.exe
   C:\UTIL\Setmode.exe

3. Add the following commands to autoexec.bat
     C:\UTIL\Setmode MONITOR

4. Shutdown and reboot.