1. UP20-4.exe Driver
2. Read1st.txt File Contents

Read1st.txt Driver File Contents (UP20-4.exe)

Procedures for upgrading your firmware: to V1.120
					(For HM18020-4 Only)


Note: make sure the screen saver is disable before 
      performing the task below, this way it will eliminate
      any interruption during the installation.

1) Make sure the modem were properly configured, go to Control 
   Panel Modem icon Diagnostics folder highlight the COM port 
   where the modem installed then click "More Info" and wait.  
2) Look at the ATI3 because this is you current firmware version.
   Then double click "OK".
3) Inserts the diskette that has the files from UP20-4.exe 
   in drive A, then extract the file to drive A***. 
   Then click on start, run, type a:\flashcom.exe, and then wait 
   until it detects the modem.
5) Choose LOAD NOW and click OK when prompt "are you sure" at 
   this point the software should extract and proceed with the 
   upgrade.
7) When finished, you will see a verification of the firmware 
   upgraded version were the modem installed, choose CLOSE to 
   exit the program.
8) End of installation.


Remark *** After you extract the UP20-5.exe
     Logo.bmp	     ;Harmony Multimedia Logo
     flashcom.exe    ;Flash ROM upgrade program for Win3.1 or Win95.
     flashcom.hlp    ;Flash ROM loader Help menu. file.
     flashcom.ini    ;Initial the Flash ROM load file name.
     read1st.txt     ;instruction file
     bpflv37.s37     ;The 1st load file to modem.
     js3-c0a.s37     ;The 2nd load file(Target file) to modem.                
   


Harmony Multimedia
http://www.harmonyusa.com/    

How To Update Drivers Manually

After your driver has been downloaded, follow these simple steps to install it.

• Expand the archive file (if the download file is in zip or rar format).

• If the expanded file has an .exe extension, double click it and follow the installation instructions.

• Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.

• Find the device and model you want to update in the device list.

• Double-click on it to open the Properties dialog box.

• From the Properties dialog box, select the Driver tab.

• Click the Update Driver button, then follow the instructions.

Very important: You must reboot your system to ensure that any driver updates have taken effect.

For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.