LINUX.TXT Driver File Contents (100v34.zip)

******************************linux.txt**************************************
*                                                                           *
*                         PCI FAST Ethernet Adapter                         *
*                                                                           *
*                      Ethernet Driver for Linux                            *
*                                                                           *
*                         V. 2.01,   July. 1998                             *
*                                                                           *
*****************************************************************************
                 
         
Introduction:
=============

     Below are instructions for install linux driver.You must complie the source
   code to generate driver.o and use insmod to insert driver.o as module .
   You can use "netconfig" utilities to setup network parameters for the driver.


Contents of the Subdirectory:
=============================

    fet3043.c              The linux driver source code
    fet3043.o              The linux driver but maybe cannot be used in various version
    linux.txt              This file.


Installation:
=============

    
    1)Now enter the following commands at the UNIX prompt.  Remember, UNIX is case sensitive.
      mkdir /temp
      mcopy a:fet3043.c /temp (copies from DOS disk to current working directory)
                              (mcopy is mtools if you don't have mtools,you can mount -t /dev/fd0 and use cp command)
      mcopy a:trans /temp
      cd /temp                 
      chmod 777 *                (add all right to all file)
           
    2) run trans file to complie and copy driver to linux source code:
       /temp/trans 

    3) Run netconfig to set you network parameter(like ip,gateway),This will create
       '/etc/rc.d/inet1' and 'inet2' files.

    4) you must modify /etc/rc.d/rc.inet1 to insmod driver.This file will run at boot time. 
       add a line in rc.inet1:
       cd /etc/rc.d 
       vi rc.inet1  
       insmod /your driver'path/fet3043.o
       ex:insmod /usr/src/linux/modules/fet3043.o (must before bind protocal)
       shutdown -h now    (then your driver will work every time you boot.)
       


    Note:make sure that your kernel is built with network, fast_ethernet and module
          support. Otherwise, you have to rebuild your kernel.

 	 1:go to /usr/src/linux directory
         2:run 'make menuconfig' or 'make config'
         3:mark the options list above.
         4:exit and rebuild your kernel.
            make dep;make clean;make zImage
           the file 'zImage' will be at /usr/src/linux/arch/i386/boot/zImage
         5:modify /etc/lilo.conf.(this file specify where kernel image is)
         6:run 'lilo'  

     
      
     
   



        
     
      





Download Driver Pack

How To Update Drivers Manually

After your driver has been downloaded, follow these simple steps to install it.

  • Expand the archive file (if the download file is in zip or rar format).

  • If the expanded file has an .exe extension, double click it and follow the installation instructions.

  • Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.

  • Find the device and model you want to update in the device list.

  • Double-click on it to open the Properties dialog box.

  • From the Properties dialog box, select the Driver tab.

  • Click the Update Driver button, then follow the instructions.

Very important: You must reboot your system to ensure that any driver updates have taken effect.

For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.

server: ftp, load: 1.86