PowerVault 136T Tape Library Firmware Release Notes These release notes are applicable to the following firmware versions: * PowerVault 136T Library Firmware 2.60.40 * PowerVault 136T Remote Manage Card Firmware 131d.00012 * PowerVault 136T LTO Tape Drive Firmware E15V 4.211 * PowerVault 136T FC Module Firmware 4.03.06 PowerVault 136T Library Firmware 2.60.40 Previous version: 2.40.16 and 2.40.17 The following problems are fixed: * Repeated SAC A0 errors when the library is left idle overnight * Library fails to recognize the mail slot after power on or a door open close condition. This results in the following message on the LCD, ERROR!. * Library fails to recognize installed cartridge magazines or columns. * SAC A0 is generated when removing the remote management card from the library. * Communication problems between the library and tape drive resulting in a Drive Communication Error message on the library LCD. * Drive firmware update through remote management card fails on the 2nd drive in a multiple-drive firmware update * SAC 42 errors where the bar code scanner is unable to detect and installed mailbox * SAC 43 errors where the library is unable to read the configuration label installed on storage columns or storage magazines * Support for 7 digit Dell Service Tag The following enhancements are added: * Support for 7 digit Dell Service Tag PowerVault 136T Remote Management Card 131d.00012 Previous version: 130d.00013 The following problems are fixed: * Firmware downloads to the tape drives via the remote management card would fail if 4 or more drives were selected simultaneously. * Remote management card hang conditions * SNMP traps are enabled during power up sequence. * DHCP support has been removed The following enhancements are added: * Support for 7 digit Dell Service Tag * Enabling of the diagnostics tab * Link added to return the user from detailed status page back to normal status page. PowerVault 36T LTO Drive Firmware E15V 4.211 Previous version: E15V 4.147 The following problems are fixed: * LTO Drive READY LCD stops flashing after an expired cleaning cartridge has been inserted into the drive * Improved communications between LTO Drive and the library over the drive's serial interface The following enhancements are added: * LTO Drive front panel TAPE ERROR light flashes after a drive error PowerVault 136T Fibre Channel Module Firmware 4.03.06 Previous version: 4.02.08 The following problems are fixed: * Target Reset does not post proper sense data of 06 29 00 * FC loop back test now works properly * The FC module now properly senses between 1 GB and 2 GB * Extended copy stream problem when multiple extended copy commands are running * supportDump properly captures all data * Extended copy stream fix to discard buffer handling * Allow READ BLOCK LIMITS and REPORT DENSITY SUPPORTED when there are reservations on a sequential access device * Link statistics now report proper information instead of unavailable from GUI The default setting for the FC ports is auto sensing * Added 0x0F segment descriptor support for data moverDownload Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.