1. FT_NWB10.exe Driver
2. NW_411.txt File Contents

NW_411.txt Driver File Contents (FT_NWB10.exe)

NWPA Update Package Installation Instructions for NetWare 4.11

Before installing the FastTrak NetWare driver, make sure 
that you have installed the latest update for the NetWare 
4 operating system.

1.	From the website at 
	http://developer.novell.com/devres/sas/certinfo.htm 
	download NWPA_UP.EXE from the "Download the Update 
	Package" link.
2.	Install DOS and the CD-ROM driver on the target server 
	machine.
3.	Create the directory C:\UPDATE, and then change to that 
	directory.
4.	Copy NWPA_UP.EXE to C:\UPDATE.
5.	Execute NWPA_UP.EXE in the C:\UPDATE directory.
6.	Delete NBI31X.NLM, NWTAPE.CDM, and NWTAPE.DDI.
							

For New Netware 4.11 Servers:

Note: 	If your server already has NetWare 4.11 installed, jump 
	to step 7 of the next section "For Existing Netware 4.11 
	Servers."

7.	Change directory to the D:\ directory on the CD-ROM drive, 
	if its drive letter is D:
8.	Enter install at the DOS command line. Proceed through the 
	installation of NetWare 4.11 as usual.
9.	When prompted by Install to select a device driver to load, 
	select the FASTTRAK.HAM driver.
10.	Switch to console mode by using <ALT><ESC> before continuing 
	installation, and type "load c:\update\IDEHD.CDM". Do this is 
	to make sure that the IDEHD.CDM is version 2.00 (1998-8-5) or 
	newer. (The older default IDEHD.CDM doesn't support LBA mode 
	addressing, and will have problems with the FASTTRAK.HAM driver.)
11.	After IDEHD.CDM is loaded, use <ALT><ESC> to switch to the 
	installation monitor and proceed through the installation of 
	NetWare 4.11 as usual. When the installation program prompts you 
	to edit STARTUP.NCF, enter the following lines after any set 
	parameters but before any file loading, then save the file:
	
	load c:\update\nwpa
	load c:\update\nbi
	load c:\update\idehd.cdm

12.	DOWN and EXIT the server.
13.	Reboot the server.


For Existing Netware 4.11 Servers:

7.	Copy the Fasttrak driver FASTTRAK.HAM & FASTTRAK.DDI into 
	the Netware 4.11 boot directory. Ex. C:\NWSERVER\
8.	Edit STARTUP.NCF and add the following lines after any set 
	parameters but before any file loading:

	load c:\update\nwpa
	load c:\update\nbi
	load c:\update\idehd.cdm

    	Also add subsequent line "load FastTrak" to load the 
   	FASTTRAK.HAM driver.

9.	Boot the server.