1. DR-ENW9601_2v131.zip Driver
2. Readme.txt File Contents

Readme.txt Driver File Contents (DR-ENW9601_2v131.zip)

 ==============================================================

        PLANET ENW-9601T/ENW-9602T Gigabit Ethernet Adapter
	         Driver Installation For Solaris

 ==============================================================

	    Copyright (C) 2002 PLANET Technology Group.
		       All rights reserved.



  Content:
  --------

  Install the PLANET ENW-9601T/ENW-9602T Gigabit Ethernet Adapter
  on Solaris 

Software Requirements:
1. Solaris OS version 5.7 for Intel
2. Sun Workshop compiler 5.0 for Intel

1: Copy the compressed archive to the build directory

	#cp dp_solaris.tar.Z /export/home/build

2: Uncompress tar archive

	#cd /export/home/build
	#uncompress dp_solaris.tar.Z
         
3: Unarchive the tar file.

	#cd /export/home/build
	#tar -xvf dp_solaris.tar

4: Build the driver files

	Refer to README file under /export/home/build/sol directory

5: Copy the driver file and configuration file to the sol/pkg directory.

	#cp dp dp.conf /export/home/build/sol/pkg

6: Change the owner and group id of pkg directory and all the files in 
   it as below.

	#cd /export/home/build/sol
	#chown root pkg
	#chgrp sys pkg

	#cd /export/home/build/sol/pkg
	#chown root*
	#chgrp sys*

7: Execute the following command to build the package dp83820.

	#cd /export/home/build/sol/pkg
	#./buildpkg /export/home/build/sol/pkg
   
   This creates the dp83820 package under /export/home/build/sol/pkg directory

Installing the package.
-----------------------
1. Execute the following command to add the dp83820 package to the system.

	#pkgadd -d /export/home/build/sol/pkg/dp83820


Configuring the adapter.
------------------------
Following are the steps for configuring the adapter.

1. Edit /etc/hosthome.<interface>
   (And enter only the Machine name in /etc/hostname.<interface>,
     Machine name is got by typing "uname -a" at the prompt)

2. Edit /etc/hosts (Enter the <IP Address> <Machine name>)

3. Edit /etc/netmasks (Enter the <network-number> <netmask>)

4. Execute the following command to configure the adapter after adding 
   the package.

	#/opt/dp83820/configure_adapter dp0 <IP Address>

Uninstalling Package.
---------------------
1. Execute the following command to unconfigure the adapter.

	#/opt/dp83820/unconfigure_adapter dp0

2. Execute the following command to uninstall the package and driver 
   from the system.

	#pkgrm dp83820