1. DR-ENW9506.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (DR-ENW9506.zip)

   LAN Manager Workstation/Server

   Introduction:
   -------------
   This document describes the procedure to setup LAN  Manager 2.1
   Workstation/Server driver for PLANET ENW-9506 PCI Fast Ethernet Adapter.

   Location of Driver:(DOS) \NDIS\FETND.DOS
                      

   Sample Configuration Files:
   ---------------------------
      CONFIG.SYS (for DOS will contain):

          DEVICE=C:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /I:C:\LANMAN.DOS
          DEVICE=C:\LANMAN.DOS\DRIVERS\ETHERNET\FETND\FETND.DOS


          PROTOCOL.INI (will contain):


    DRIVERNAME    = FETND$

; AUTO = 1 or 0        Enable Auto Negotiation
; SPEED = 10 or 100    Set line speed = 10 or 100 Mbps
; FULLDUPLEX = 0 or 1  Set to FullDuplex or HalfDuplex
; SLOT = 1             Set physical slot of adapter,  
;                      Usful for 2 adapters. 
; CONNECTIONTYPE =  AUTOSENSE       Enable Auto Negotiation
;                   _10BaseT        Set line speed=10, halfduplex mode
;                   _10BaseTFD      Set line speed=10, fullduplex mode
;                   _100BasetTX     Set line speed=100, halfduplex mode
;                   _100BasetTXFD   Set line speed=100, fullduplex mode
; FLOW_CONTROL = HARDWARE_DEFAULT   Set to use hardware's default flow control ability
;                ENABLE             Enable flow control ability
;                DISABLE            Disable flow control ability



   Setup driver procedures on LAN Manager workstation/server :
   -----------------------------------------------------------
      Before you start with the installation process, make sure that the
      adapter  is properly  installed  and  configured. Make  sure  your
      Microsoft LAN Manager is properly installed.

      1. Run the appropriate Microsoft Lan Manager SETUP for computer you
         are setting up.(DOS). Select "Configuration"
         item ,(the VIA driver isn't included on the Lan Manager disk)
         and insert the ENW-9506 driver disk,  select the Realtek
         driver and follow the directions.

      2. When completed, reboot your computer.

How To Update Drivers Manually

After your driver has been downloaded, follow these simple steps to install it.

• Expand the archive file (if the download file is in zip or rar format).

• If the expanded file has an .exe extension, double click it and follow the installation instructions.

• Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.

• Find the device and model you want to update in the device list.

• Double-click on it to open the Properties dialog box.

• From the Properties dialog box, select the Driver tab.

• Click the Update Driver button, then follow the instructions.

Very important: You must reboot your system to ensure that any driver updates have taken effect.

For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.