Zoltrix Communication CD-ROM Volume 3.5-FT Table of contents I. Introduction II. Windows 95 Modem Installation Notes III. Communications Software Installation IV. Trial Version Software V. Modem Manuals I. Introduction The Zoltrix Communication CD-ROM contains communication software and modem drivers required for your modem. Also included on the CD-ROM is a trial version of the 32 bit FaxTalk Messenger software intended for Windows 95. II. Windows 95 Modem Installation Notes The Windows 95 modem drivers for most models are located in the Root directory of the CD-ROM. The exception to this are the some Windows modems. The location of the drivers for the windows driver not found in the root directory are listed below. FM-HSP336p Modem Installation Note 1. When prompted for the Driver Installation disk, select D:\PCTEL\HSP336P (Replace D: with the drive letter of your CD-ROM drive if neccessary) 2. Follow the onscreen directions. FM-HSP56p Modem Installation Note 1. When prompted for the Driver Installation disk, select D:\PCTEL\HSP56P (Replace D: with the drive letter of your CD-ROM drive if neccessary) 2. Follow the onscreen directions. FM-HSP56PCI Modem Installation Note 1. When prompted for the Driver Installation disk, select D:\PCTEL\HSP56PCI (Replace D: with the drive letter of your CD-ROM drive if neccessary) 2. Follow the onscreen directions. FM-SFT56i Modem Installation Note 1. When prompted for the Driver Installation disk, select D:\FMSFT56i (Replace D: with the drive letter of your CD-ROM drive if neccessary) 2. Follow the onscreen directions. 3. If you are using the S3 PCI VGA and having problems with FM-SFT56i, install the Driver Patch located in D:\FMSFT56i\Patch\Cpatch.exe. Modem Installation Note (Other Models) 1. When prompted for the Driver Installation disk, select D:\ (Replace D: with the drive letter of your CD-ROM drive if neccessary) 2. Select the correct model # found on the Quick Installation Reference Card 3. Click OK. 4. Follow the onscreen directions. Note: Before installing the modem driver you may need to let Win95 autodetect the Modem port if it is not detected. III. Communication Software Installation The Zoltrix Communication CD-ROM contains more than one version of the FaxTalk software. There is one version for non voice modems, one version for modems using a Rockwell voice chipset and one version for modems using a PCtel voice chipset. You will also find a 32 bit trail version for modem using both the Rockwell and PCtel voice chipsets. FaxTalk Messenger Installation for Rockwell based Voice Modems (Models: FMVSP56i/FMVSP56i2/FMVSP56i3/FMVSP56e3/FMHCF56i/FMSFT56i/FMVSP336i) FaxTalk Messenger incorporates ultra powerful voice messaging and fax functions into a single application. The voice messaging functions include support for multiple mailboxes with password protection, fax on demand, caller ID, distinctive ring, and ultra flexible configuration. Full send and receive fax functions include support for Error Correction Mode (ECM) faxing, advanced 2-D imaging, Binary File Transfer (BFT) and Polling. This version is intended for voice modems using a Rockwell voice chipset. 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\FAXTALKV\DISK1\SETUP.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. FaxTalk Messenger Installation for PCtel based HSP Voice Modems (Models: FMHSP336i/FMHSP336p/FMHSP56p/FMHSP56PCI) FaxTalk Messenger incorporates ultra powerful voice messaging and fax functions into a single application. The voice messaging functions include support for multiple mailboxes with password protection, fax on demand, caller ID, distinctive ring, and ultra flexible configuration. Full send and receive fax functions include support for Error Correction Mode (ECM) faxing, advanced 2-D imaging, Binary File Transfer (BFT) and Polling. This version is intended for Windows HSP voice modems using a PCtel chipset. 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\FAXTALKH\DISK1\SETUP.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. FaxTalk Plus Installation for all Non-Voice Modems This version is intended for all non voice modems. FaxTalk Plus incorporates ultra powerful fax functions into a single application. Full send and receive fax functions include support for Error Correction Mode (ECM) faxing, advanced 2-D imaging, Binary File Transfer (BFT) and Polling. 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\FAXTALK\SETUP.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. Comit Installation COMit for Windows is a communications application for Microsoft Windows version 3.1 or later. You can use COMit to connect your computer to other computers and to information services such as CompuServe and Genie. This software is intended for use with all Zoltrix modem models. 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\COMIT\INSTALL.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. IV. Trial Version Software The Zoltrix Communication CD-ROM contains extra value added software. These trial versions are fully functional and give you the opportunity to try the software before making a purchase. FaxTalk Communicator {32 bit Trial version} for Rockwell based Voice Modems. (Models: FMVSP56i/FMVSP56i2/FMVSP56i3/FMVSP56e3/FMHCF56i/FMSFT56i/FMVSP336i) This is a trial version of the 32 bit Faxtalk intended for voice modems using a Rockwell voice chipset. This software is fully Win95 compatible and enables the fax and voice features of the modem. 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\32bit\FAXTALKV\DISK1\SETUP.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. FaxTalk Communicator {32 bit Trial version} for PCtel based HSP Voice Modems (Models: FMHSP336i/FMHSP336p/FMHSP56p/FMHSP56PCI) This is a trial version of the 32 bit Faxtalk intended for voice modems using a PCtel voice chipset. This software is fully Win95 compatible and enables the fax and voice features of the modem. 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\32bit\FAXTALKH\DISK1\SETUP.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. FaxTalk FaxCenter {32 bit Trial version} for all Non-Voice Modems This is a trial version of the 32 bit Faxtalk intended for non voice modems. This software is fully Win95 compatible and enables the fax features of the modem. 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\32bit\FAXTALK\DISK1\SETUP.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. SyGate software {Trial version} SyGate allows an unlimited number of networked computers to share one modem without using a proxy! This full-featured program supports dialup, ISDN, cable modem, xDSL or even dedicated Ethernet connections, and requires virtually no set-up or maintenance. Try it today for FREE! 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\SYGATE\SYGATE11.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. Atrieva software {Trial version} Now, imagine a service that secures and protects your files, no matter what happens to your computer. And what if that service made your files available to you no matter where, or when, you needed them? You're in luck! The Atrieva Service is the new online backup service that gives you total protection against the loss of your PC files. And it lets you access your files from any Internet-enabled PC, anytime, anywhere! 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\ATRIEVA\ATRIEVA.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. Web Cannon software {Trial version} WEBCANNON! Web site creation is a blast with WebCannon! WebCannon's easy point and click template interface allows users to design personal and professional Web Sites in a matter of minutes. Webcannon! ships on CD with 50 pre-programmed, themed sites complete with thousands of animated buttons, dots, icons & backgrounds. Just add your text and your personal images and you're done, your imagination is the only limit. When development is complete, simply click a button and your site is sent to the Web via regular e-mail. Finally, Web authoring software that's as powerful as it is easy to use. 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\CANNON\SETUP.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. Howdy Demo software {Trial version} HOWDY! It's e-mail with an attitude…it's ME-Mail! Quickly & easily create fun multimedia Internet postcards with Howdy! and e-mail them to friends, family & coworkers. Or with a click of button, postcards can even be turned into instant Web pages. Send postcards for all sorts of occasions from Business to Birthdays; Holidays to Sports; Leisure to Romance and more. Howdy! ships on CD with over 120 backgrounds, a ton of audio files & witty poems, all designed to help you create the perfect greeting. And remember, there's never any postage due with Howdy! 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\HOWDY\SETUP.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions. CheckIt software {Trial version} If you use a Windows 95 computer - You need Checkit! Personal computers are more complicated than ever before. Making sure your is operating at its full potential can be a time-consuming task. Just adding a new piece of hardware can take hours of frustrating troubleshooting. Not to mention the time it takes to locate and solve an actual PC problem. CheckIt solves PC problems fast! It pinpoints problems, tests your system's components, locates system conflicts, benchmarks your system's performance, and even restores your critical Windows Registry and system files. It's the perfect tool if you have a problem, and the best tool to help you avoid them. 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\CHECKIT\CK5_30D.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions V. Modem Manuals If you have lost your original modem manual, you can view an Adobe Acrobat file of the original Modem manual. The manuals are included in the D:\MANUALS Subdirectory. Following are the filenames of the manuals with the item #: FILENAME DESCRIPTION 336ACF.PDF FMVSP336i, FMVOC336Fi & FM336Fi Modem manual. {Ver 1.0 Sep 1997} VSP56i3.PDF FMVSP56i3/FMVSP56e3 Modem manual. {Ver 3.0 July 1998} FMHCF56I.PDF FMHCF56i Modem manual {Ver 1.0 June 1998} FMSFT56I.PDF FMSFT56i Modem manual {Ver 1.1} HSP336P.PDF FMHSP336p Modem manual. {Ver 7.0 Nov 1997} HSP56P.PDF FMHSP56p Modem manual. {Ver 1.1 Jan 1998} HSP56PCI.PDF FMHSP56PCI Modem manual. {Ver 1.0 August 1998} You can view the Faxtalk manuals for all the versions. The PDF files are located in the following directories: D:\FAXTALK\FTPUSER.PDF 16 bit FaxTalk Plus Software manual D:\FAXTALKV\FTMUSER.PDF 16 bit FaxTalk Messenger Software manual (Rockwell chipset) D:\FAXTALKH\FTMUSER.PDF 16 bit FaxTalk Messenger Software manual (PCtel chipset) D:\32bit\FAXTALK\FTFCUSER.PDF 32 bit FaxTalk FaxCenter Software manual D:\32bit\FAXTALKV\FTCUSER.PDF 32 bit FaxTalk Communicator Software manual (Rockwell chipset) D:\32bit\FAXTALKH\FTCUSER.PDF 32 bit FaxTalk Communicator Software manual (PCtel chipset) If you do not have the Adobe Acrobat reader, you can install it as follows: Adobe Acrobat software 1. In Windows 95: Select START then RUN from the taskbar In Windows 3.1: Select Run from the Program Manager's File menu 2. Type D:\ACROBAT3\AR302.EXE (Replace D: with the drive letter of your CD-ROM drive if neccessary) 3. Click OK. 4. Follow the onscreen directions.Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.