*****************************************************************************
* *
* PNP ISA ETHERNET ADAPTER *
* *
* Driver Installation for LINUX *
* *
*****************************************************************************
PNP ISA Ethernet Adapter is NE2000 compatable. You can use LINUX bundled
NE2000 driver (ne.o) to install.
Manual Installation Method
==========================
1. Plug PNP ISA Ethernet Adapter into PC's ISA-bus slot.
2. Boot into LINUX and add "alias eth0 ne" into the /etc/conf.modules file.
cd /etc
vi conf.modules
alias eth0 ne
3. Run the following commands at the LINUX prompt.
modprobe ne io=0x300
ifconfig eth0 192.74.53.10
4. Now, you can run 'ifconfig' or 'netstat -i' to see if there is a
interface 'eth0'.
NOTE:
ne.o only supports 0x300,0x280,0x320,0x340 & 0x360 I/O ports.
In some case, adapter(in Plug & Play mode) may be assigned one I/O
port not in the range. You can use SETUP.EXE(in DOS) to set the
card in JUMPERLESS mode and set ioaddr to one of these I/O ports.
Other Installation Method
=========================
RedHat 6.x
- Run "linuxconf" to setup your card.
Select Networking -> Client tasks -> Basic host information
-> Click Adaptor 1 to configure your adapter
For example:
Click "Enabled" (i.e. enable "Activate interface at boot time")
IP address 192.74.53.10
Netmask 255.255.255.0
Net device eth0
Kernel module ne
I/O port 0x300
Irq 5
- Save the changes and run "shutdown -r now" to reboot the system.
Slackware:
- Add "alias eth0 ne" into the /etc/conf.modules file.
- Run netconfig to configure IP.
- Modify /etc/rc.d/rc.modules:
Add one line: /sbin/modprobe ne io=0x300
----
All trademarks or brand names mentioned are properties
of their respective companies.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.