1. PAEPR090_V1.exe Driver
2. readme.txt File Contents

readme.txt Driver File Contents (PAEPR090_V1.exe)

  
  Targus Group International Driver Revision History File
  (c) Copyright 2001-2003 Targus, Inc.  All Rights Reserved.
  
  
  README TABLE OF CONTENTS
  
  1. Installation

  2. Uninstallation	
   
  3. Driver Revision History
   
  4. Known Issues
  
  ________________________________________


1.   Installation
  
  *** IMPORTANT ***
  If a previous version of the Port Replicator driver is present on your PC, be sure to 
  uninstall it prior to installing the new driver. Refer to step 2 for instructions on 
  uninstalling the drivers.

  1. To install the Targus Port Replicator from your PC, first make sure that you
     the Port Replicator is disconnected from the PC.
  2. Double-click on the "SETUP.EXE" file from the CD to run the setup application.
  3. Once the setup application is complete, reboot your system.  After the system has 
     rebooted, connect the USB cable from the Targus Port Replicator into the USB port of 
     your PC. This will initiate the hardware detection process and may take several minutes.
  4. Once all the components of the Targus Port Replicator have been detected and           
     configured, you may begin using the Port Replicator.

2.   Uninstallation

  1. To uninstall the driver, go to the CONTROL PANEL and double click the ADD/REMOVE PROGRAMS
     applet.
  2. From the ADD/REMOVE PROGRAMS dialog box, select the PAEPR090 program and click on the 
     CHANGE/REMOVE button. 


3.   Driver Revision History

  V1.0: -Initial Release

    
   
4.   Known Issues / Limitations 

  1.  Legacy software written to address physical com port directly will not function with
      the virtual com port of the Port Replicator.
  2.  Serial device support is generally limited to mice and modems. Serial device support     
      beyond mice and modems is limited.
  3.  Serial PDA cradles will not sync after suspending a machine unless the SERIAL option      
      under Hot-Sync is uncheck prior to suspending and recheck after resuming.
  4.  Multiple Targus Port Replicators installed on the same platform will cause the       
      Ethernet drivers to conflict. 
  5.  Programmable PS2 keyboards and PS2 mice may not function properly on the PS2 port's 
      of the Port Replicator.
  6.  Parallel storage devices may not function properly on the parallel port of the Port
      Replicator. 
  7.  Some printer install applications will not recognize the virtual parallel port
      installed by the Targus Port Replicator. Manual printer port configuration is required 
      for these instances.
  8.  Upon resuming from STANDBY or HIBERNATE, the serial port will be shut off. To re-enable
      the serial port, you must remove and re-insert the PAEPR090 or reboot your system.