TRENDware TE-PCI/TE-100PCI Ethernet Adapter Packet Driver
Installation for 3Com 3+ Share
Contents
ÄÄÄÄÄÄÄÄ
Introduction
Requirements
Minimum Skill Level
Getting Started
Introduction
ÄÄÄÄÄÄÄÄÄÄÄÄ
This installation assumes that the adapter is working properly.
Getting Started will describe the installation instructions.
Requirements
ÄÄÄÄÄÄÄÄÄÄÄÄ
A PCI compatible computer
3COMs 3+ Share Open Network Operating System
A PCI Family Series Adapter
A knowledge of basic DOS commands and editing text files
Minimum Skill Level
ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
A knowledge of basic DOS commands
A knowledge of editing text files
A knowledge of DOS basic file structure (CONFIG.SYS and AUTOEXEC.BAT)
A knowledge of the network driver configuration being used
Getting Started
ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
Follow the installation procedure for 3Com EtherLink board.
Copy the ETH.SYS file from the source directory of the driver disk
into the boot disk. This program will replace the program of the same
filename when the installation procedure in the first step is performed.
Ensure that the CONFIG.SYS file in the boot disk or diskette
contains the following two lines, in the given order:
DEVICE = TEPCI.SYS </d> </w> <packet_int_no>
DEVICE = ETH.SYS
<packet_int_no> is the software interrupt vector number used by the
packet driver program. This can be from 96 to 128.
/d Delay Initial - The driver program will not initialize
the network interface card until the packet driver
program is accessed by its upper layer program.
/w The /w parameter is for use only in the Windows
environment.
See \PKTDRV\README.TXT for addition parameters
You may now reboot and to start workstation.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.