DiskGo! has not detected an ATA drive on your system. Several reasons can cause DiskGo! to make this conclusion. No ATA drives, continue with this procedure at the next step. A device driver hooking Interrupt 13 and not reporting back ATA information. If the device driver (i.e. disk cache) is loaded under windows, uninstall it. If a message is displayed while running DiskGo! stating, Dynamic Drive Overlay DDO will be loaded DO NOT reinstall the removed device driver. If you have a SCSI hard drive as your boot drive, DiskGo! cannot be used to install the new ATA drive. You must follow the procedure outlined below: (For Windows 3.1x only, this procedure cannot be used for Windows 95.) NOTE: Once you add an ATA hard drive to your system, the SCSI drive will no longer be the boot device. Therefore, you will need to copy all the files from your SCSI drive to the new ATA drive to be able to boot and run your system. - Create a DOS system bootable diskette. (Place blank diskette in your A: drive and type "format a: /s" from the C: prompt, or "sys a:" if the diskette is formatted but has no files on it.) - From the DOS C: prompt, type "cd\DiskGo!" and [ENTER]. If you chose a different name for the DiskGo! directory, type the appropriate directory name. - Type "copy filecopy.exe a:" to copy the file to the diskette you just created. - Install the new ATA hard drive with jumpers set for a single drive. See the jumper information listed on the Fujitsu hard drive. - Re-boot the system with the boot diskette you just created in the A: drive. - Insert the DiskGo! diskette in your A: drive, (or B:, as needed) and run Disk Manager by typing "dm" at the A: (or B:) prompt. - Select "Easy" or "Advanced Install" as you wish. - Once the Disk Manager program has installed the new hard drive, you will need to copy the files from your existing SCSI drive to the new ATA drive. - Insert the boot diskette you created into the A: drive. - Type "filecopy". - When asked for the source drive, press "D" and [ENTER]. - When asked for the destination drive, Press "C" and [ENTER]. - Press [ENTER] to begin copying all the files to the new drive. - Once the filecopy has completed successfully, remove the diskette from the A: drive and re-boot the system. - At this point the installation is complete, and the system will boot normally from the new Fujitsu ATA hard drive.Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.