1. R150932.EXE Driver
2. readme.txt File Contents

readme.txt Driver File Contents (R150932.EXE)

Dell Laser Printer W5300 Firmware Update


The following files are found in this release:

· This instruction sheet in .txt formats

· 55_10_87.fly  – update package for the printer network code. 
 

To upgrade the W5300 printer network firmware:

1. Make sure the printer is in the Ready state, i.e. the “Ready” is displayed on the printer LCD.

2. Go to the Printer’s Embedded Web Server by opening a web browser and entering the IP address of the printer into the address field, then click “GO”

3. Once the embedded web page has displayed, click the “Printer Settings” link on the left frame of the web page. The Printer Settings Page will be displayed.

4. Under the “Other Features” section on the right side of the page, click the “Update Print Server Firmware” link.

5. On the Update Print Server Firmware page, click the “Browse” button to open the “Browse for File” window. Browse to the location where the files were saved (i.e.; C:\Dell\Drivers\R103128) and select the file 55_10_87.fly, then click the “Open” button.

6. On the Update Print Server Firmware page, verify the “File Name:” entry contains the file 55_10_87.fly, then click the “Flash” button. The “Status” changes from “Idle” to “xx% Sent”. 

7. Once 100% of the file has been sent to the printer, the firmware in the printer will be updated.  DO NOT POWER OFF THE PRINTER WHILE THIS IS OCCURING.

8. The printer will automatically perform a power on reset when the firmware has successfully updated. This normally takes about 60 seconds.
 

KEY FEATURES AND BENEFITS OF THE RELEASE:

Adjusted DST begin and end dates for AST, EST, CST, MST, PST, Alaska, and Newfoundland time zones to comply with 2007 DST changes.