DIAG.TXT
Information about ICL EtherTeam 16i/32 Diagnostic Program.
The ETH16I.EXE Diagnostics Program can be used to test the EtherTeam 16i
and EtherTeam 32 EISA adapters. The program includes parameter settings
to configure the test environment. In the following sections the most
important parameters are explained.
ETH16I
This is the default start. it starts the test and assumes that the adapter
is connected to the network with any of the ports on an COMBO/DUO adapter
tp the TP port on an TP adapter.
ETH16I /NONET
This parameter runs the test in internal loop back mode. This means that no
network connection or test plugs are needed.
ETH16I /BNC
ETH16I /DIX
ETH16I /TP
These parameters runs the test selecting the specified port. When running
the test in this mode the LAN must be connected to the selected port.
ETH16I /ECHO300 /IO2A0 /REC
These parameters runs the test in echo mode in one machine with two
EtherTeam 16i adapters. One adapter with IO address 300 is selected as the
echo adapter and the other adapter with IO address 2A0 is selected as
adapter to be tested. The adapter to be tested transmits packets trough
the connected LAN port to the echo adapter which echoes the packets back
to the adapter to be tested. To run this test both adapters must be
connected to the same LAN. Note also that this test may block other traffic
on the LAN, so it's wise to use a dedicated LAN for this test. Note that the
IO addresses for the EISA adapters are slot specific (e.g. IO5000 when
the adapter is in slot 5).
ETH16i /ECHO ( in echo PC )
ETH16i /REC ( in test PC )
These parameters do the same as the previous echo mode test with the
exception that the echo adapter and the adapter to be tested are installed
into two different PC's.
ETH16i ?
This parameters shows help text and information about the different
parameters for the EtherTeam 16i Diagnostics Program. To read this help it
is useful to load in your PC ANSI.SYS to get the texts in more readable
format.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.