1. 2216sco5.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (2216sco5.zip)

		    Accton SmartEnabler Installation
		       FOR  SCO UNIX


README.TXT	This file
		Installation procedure file
SCOLSEN.TAR	Accton SmartEnabler driver for SCO UNIX tar format

------------------------------------------------------------------
Note for Scenic 500/700:  Pleas set your notebook BIOS Plug and Play OS to NO.
-------------------------------------------------------------------

      1.0 Installation for SCO5 enabler from tar file

      1.1 To install the Accton SmartEnabler from file to SCO5:
	  -----------------------------------------------------------

	1. Go to the /tmp in Unix system.

		cd /tmp 			<Enter>

	2. Copy the scolsen.tar file from the DOS diskette to /tmp directory:

		doscp a:scolsen.tar scolsen.tar.Z <Enter>

	3. uncompress the file:

		uncompress scolsen.tar.Z scolsen.tar		 <Enter>

	4. package installation diskette ( floppy A)

	      #dd if=./en166xdriver of=/dev/rfd0135ds18 	 <Enter>

       (Note: Use another device file name if you use different floppy drive)

   Now the package installation diskette is ready for installing.



	5. Install the smart enabler  using the custom command


		custom	       <Enter>



	Note:	This driver for SCO  will auto-detect the installed
		NE2000 or (nat0) driver and set the IO and IRQ
		accordingly.  If the NE2000 or nat0 is not installed
		it will set the IO and IRQ to default values
		at IO=0x300 and IRQ=5.

	Note also:  Please remove the old driver before installing the new one.
	Please make sure your notebook configuration will NOT conflict.


	After running the custom utility and the new package is installed,
	you should use the "netconfig" command to add the driver into your
	system like the step 6 below.

	6. Run "netconfig". Add the desired chain. The NE2000 driver are
	called:
	Remember the nat0 must be configured first, before any
	other driver is configured.

	7. When the chain has been configured, select 'q' from the
	   netconfig menu. and relink the kernel at the prompt.

	8. To active the adapter, you must reboot. When the system
	   boots, you should see the following message among the
	   other configuration messages:

    %natn0  0x0300-0x0319   3	-   type=NE2000 addr=00-00-e8-xx-xx-xx

	   with the appropriate I/O addresses, IRQ, Adapter Type and IEEE address.
	   The display of last three bytes of IEEE address depends on the adapter
	   currently plugged onto your system.

	9. If you encounter any problems during installation,
	   (i.e., an error message appears on screen) call your dealer for assistance.