1. wlsb101.ZIP Driver
2. help.txt File Contents

help.txt Driver File Contents (wlsb101.ZIP)

Installtion:
============

1) Insert the installation disk in drive A

2) From Windows desktop, open drive A and click Start

3) The software will automatically select Compex WL11 and
   your wired LAN adpater as a bridge pair. Click Install button
   to continue. Goto step (4)

   If you have more than one wired LAN adapters installed in the
   PC, it will display the list of these adapters and prompt you
   to select one that you will use to bridge with Compex WL11 adapter.

4) After selecting the bridge pair, click Install button.
   After the files are copied and the registry setup is done,
   it will prompt to restart the PC. Click the Restart button.

5) When Windows is up and running again, the bridge is in operation.
6) Installation completed.


Known Issues:
-------------
1. Currnet release only support Win9x and Win Me
2. Bridge only support TCP/IP protocol now.
3. Only the PC with Compex's PCI wireless card can act as a bridge.
   Other notebook and PCs with other brand wireless card can only
   be use a wireless nodes to access through the bridge to the wired LAN.
4. Compex WL11 on both the stations and bridged PC should be configed to
   Ad-Hoc mode.
5. Same IP subnet on both sides of the softbridge is recommended
6. Wireless nodes will not be able to access bridged PC shared resources.
   If wireless nodes must access bridged PC shared resources then additional
   network protocol like NetBEUI must be added on both wireless nodes and
   bridged PC.
7. Don't install two bridges that have the same subnet and same freqency
   domain to the same wired network. This may cause IP conflict problem on
   your network.
8. Install/Uninstall/Config of the bridge can also be setup through the
   Control Panel->Network
9. Use the service utility to do simple control: disable/enable

2001.03.27