1. 32-bitRealtekRTL8029.zip Driver
2. INIT.TXT File Contents

INIT.TXT Driver File Contents (32-bitRealtekRTL8029.zip)

                   32-Bit IO Mode PCI Ethernet Adapter
                         Initialization Program
                   ===================================

1. Introduction:

        This program, E32INIT.EXE, is an initialization program for 32-Bit
        PCI adapter.  It can initialize the adapter to be compatible with
        NE2000 drivers.


2. How to use the program:

   2.1  Device Driver
        Include the following into your CONFIG.SYS:

        USAGE:
              DEVICE      = E32INIT.EXE IO=xxxxh, IDX=x
        or    DEVICEHIGHT = E32INIT.EXE IO=xxxxh, IDX=x

   2.2  Running the following in DOS command prompt:

        USAGE:
              C:> E32INIT IO=xxxxh, IDX=x
        or        E32INIT ?     (show help message)



  Note:
  -----
    IO:   assigning the I/O ports base address for your LAN adapter, it need 32
          contiguous ports for working properly.  Make sure the LAN adapter
          I/O ports do not conflict with other devices in your machine.
          If you do not specify the I/O, the E32INIT will use the address
          assigned by PCI BIOS as its I/O port BASE address.

    IDX:  It specifies which LAN adapter card is initialized.  You should
          use this parameter when you have more than one 32-bit adapter
          in your PC.

   2.3  Example:
                DEVICE = E32INIT.EXE
                DEVICE = E32INIT.EXE IO=300h
                DEVICE = E32INIT.EXE IDX=0
                DEVICE = E32INIT.EXE IO=D020h IDX=1

                C:\> E32INIT
                C:\> E32INIT IO=240h
                C:\> E32INIT IO=F060h IDX=0

   2.4  When the E32INIT is excuting, the screen displays the adapter's I/O
        port address, IRQ number and Ethernet address.  All of the above
        information is required for running NE2000 driver. (!! You must
        specify the I/O BASE and INTERRUPT values in the PROTOCOL.INI
        as running NE2000 NDIS2/DOS driver)


3. Running NE2000 DOS/ODI driver:

   Example:     C:\> E32INIT IO=300h
                C:\> LSL
                C:\> NE2000
                C:\> IPXODI
                C:\> VLM

   NET.CFG:
   --------
                      .
                      .
                      .
                LINK DRIVER NE2000
                     Port  300
                     IRQ   11
                      .
                      .

   Port and IRQ values will be displayed after execute the E32INIT.EXE!!


4. Running NE2000 NDIS/DOS driver:

   CONFIG.SYS
   ----------
                      .
                      .
                      .
             DEVICE=C:\LSP\E32INIT.EXE IO=D000h IDX=0
             DEVICE=C:\LSP\PROTMAN.DOS /i:C:\LSP
             DEVICE=C:\LSP\NE2000.DOS
                      .
                      .
                      .


   PROTOCOL.INI
   ------------
                      .
                      .
                      .
             [NE2000_NIF]
                DRIVERNAME = MS2000$
                IOBASE     = 0xD000
                INTERRUPT  = 9


==============================================================
**  All trademarks or brand names mentioned are trademarks or
    registered trademarks of their respective companies.
==============================================================