1. en1204.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (en1204.zip)

                Accton Technology Corporation
                Packet Driver Installation
                ==============================

Copyright (c) 1992, 1993 by Accton Technology Corporation.
All rights reserved.

Requirements
------------
* Accton Driver Diskettes

Installation Procedure
----------------------
1. Insert the Driver Diskette in your floppy drive A: or B:
2. Check the contents of the \PKTDRV subdirectory. It
   should contain the VLNWPD.COM file.
3. Load the packet driver. From DOS, type the following
   command and press <Enter>:

   VLNWPD 0X60 0XD000

   The syntax for the VLNWPD command follows:

VLNWPD [-d] [-e] [-n] [-w] [-u] [-h] <PD_INT_NO> [MEM_BASE] [IRQ] [IO_BASE]

   The parameters enclosed in square and angle brackets are optional.
   The following describes each one:

    -d         delay driver to initial LAN card
    -e         you can exchange the running sequence of EII & 802.3
    -n         convert ETHERNET_II header to IEEE 802.3 header
    -w         let packet driver run under WINDOWS
    -u         unload the packet driver
    -h         on line HELP

  PD_INT_NO    packet driver INT entry (0x60 to 0x80)
  IRQ          IRQ setting 2, 3 (Default), 4, 5, 10, 11 ,12, 15
  IO_BASE      I/O base 300 (Default), 320, 340, 360
  MEM_BASE     SHARE RAM memory address D000 (Default), D400, D800,
               DC00 C000, C400, C800, CC00

Important note:
  The IRQ and IO_BASE settings should be the same
  as the adapter's hardware configuration. If you are using
  the default adapter settings, you may omit typing these
  values.

Example
-------
The following command line loads the Packet Driver
for Accton's EN1204 at software interrupt 60h, at I/O
address 300, at hardware interrupt 3, at shared RAM address D000.

VLNWPD 0x60 0XD000 0x3 0x300

or

VLNWPD 0x60

Note that the default I/O address is 300, IRQ is 3.
The software interrupt should always be preceded by
"0x"

==End==


How To Update Drivers Manually

After your driver has been downloaded, follow these simple steps to install it.

• Expand the archive file (if the download file is in zip or rar format).

• If the expanded file has an .exe extension, double click it and follow the installation instructions.

• Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.

• Find the device and model you want to update in the device list.

• Double-click on it to open the Properties dialog box.

• From the Properties dialog box, select the Driver tab.

• Click the Update Driver button, then follow the instructions.

Very important: You must reboot your system to ensure that any driver updates have taken effect.

For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.