1. CardReader_Gateway_1.10_XPx86XPx64_A.zip Driver
2. Readme1_10.txt File Contents

Readme1_10.txt Driver File Contents (CardReader_Gateway_1.10_XPx86XPx64_A.zip)

Digital Media Reader 1.10

Intended platform:
	Emachines/Gateway Desktop reader
	Supports IOI VID/PID of VID=0A48/PID=3239
	Supports Northstar VID/PID of VID=058F/PID=9360 old TAR01 and TAR02
	Supports AU9362 and AU9368

When installing the Digital Media Reader the following process must be followed:

NOTE: This version will support all 3 media readers(IOI, Northstar TAR 01, and Northstar 
	TAR 02(LC)). 

2. Plug in BOTH IOI PID=3239 AND NS PID=9360(TAR 01) and NS PID=9360(TAR02-LC)
   reader into the system at the same time in different USB port 
   (there may be minor work to twick USB wires for 2nd and 3rd reader in the 
   system as both IOI and NS reader use internal USB cable)

   NOTE: If you want the icon software to only work with Northstar desktop media reader, then you
	 do not need to plug in the IOI media reader. Or if in the future, when Northstar will 
	 no longer ship the TAR 01 reader(old), then you will no longer need to plug in the old 
     	 Northstar reader(TAR 01).

3. Run the installation software to completion and success
4. At this point, if you still have all 3 reader plugged into the system, you will see
   12 drive icons(4 for IOI, 4 for Northstar-TAR 01, and 4 for Northstar TAR 02). 
5. Remove any 2 of the 3 drives.
6. System is reader to work with both Northstar or IOI 8-in-1 reader
7. The system is ready to get imaged.

Change Control:
11/15/2004

	1. This version of the icon software does NOT require a reboot after installation. The 
	   changes will take effect immediately after the installation process.
	2. This version supports all 3 media readers. IOI, Northstar TAR01, and Northstar TAR02
	3. This version can be uninstalled without any of the readers being physically plugged into
	   the system.
	4. Control Panel version is 1.10