Information file for firmware release V3.012/3.010 for SUNNY ISLAND 2012 / 2224
General:
========
This firmware supports the device SUNNY ISLAND 2012 and 2224.
The update is being done by copying the file "UPDATE.BIN" to an
SD/MMC-Card and inserting this card into the SD/MMC-card slot
of the SRC-1 (SUNNY REMOTE CONTROL 1), while the SUNNY ISLAND is in
STANDBY mode.
Slave devices which are connected to the master unit via
communication do not have to be updated explicitly. The master
unit is updating the slave units automatically.
If a slave unit has been updated accidentally while the master
unit still has the older version of the software, this will be
detected by the master unit and the slave unit will be set to
the version of the master unit automatically.
CAUTION: If you have a system with more than 1 SUNNY ISLAND, and
different firmware versions, always install the latest firmware version
on the master. Alternatively, you can configure the unit with the latest
firmware version as master.
CAUTION: This firmware version is for SUNNY ISLAND 2012 and 2224
only and not for other devices of the SUNNY ISLAND family. By updating the
firmware, no parameter which has been set in advance will be
deleted as long as this is not explicitly explained in this text
file.
For safety reasons the parameter list should be stored on the
SD/MMC-Card (please see manual: "10.3 Storing Data on an MMC/SD Card".
During firmware update the battery management could be reset automatically.
For more information, see manual: "10.3.6 Firmware Update".
Changes to previous versions:
=============================
- The same firmware release (v3.012/3.010) can be used for both devices, the SUNNY
ISLAND 2012 and the SUNNY ISLAND 2224.
- New Feature: 3-phase operation (3phase)
- New Feature: 1-phase parallel operation (1phase2 and 1phase3)
- New Feature: Sleep mode
- New Feature: Battery line resist can be set (voltage drop of the battery wire leads)
- Improved Search mode
- Improved load dependent generator start (dependent on apparent power)
- Failure confirmation no longer restricted to home screen
- Modification: Firmware update only possible in standby mode or error status
- Modification: Reset of the number of autostarts of the Sunny Island after 10 minutes
when autostart has expired
- Modification: Power bar with overload symbol ">" if the cluster maximum power
has been exceeded
- Minor bugfixes
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.