1. SB8200_Touch.zip Driver
2. readme.txt File Contents

readme.txt Driver File Contents (SB8200_Touch.zip)

*********************************************************
Bematech / Logic Controls touch panel driver instructions
Product: SB82000

**********************************************************

1 - Run setup.exe as administrator:  right click -> run as adminstrator (for Vista and Win7 users)
2 - Follow screen instructions


IMPORTANT : If your touch panel is not detected automatically, an error message will appear and you'll have
to install the driver manually according to the procedure below:


PROCEDURE STEPS

1st Step ?Identify the installed touch  panel
	There are 2 different touch panel suppliers for the SB8200: ITC or ACMEPOINT (eGalaxy). 
	It is not possible to identify the panel by its outside look. You need to check the USB hardware/vendor id 
	from Windows Device Manager (or using similar tools in other Operating System (i.e. “lsusb?in linux). 
	For ITC panels, the vendor id is 0x1CBC and product id is 0x6680. For AcmePoint (eGalaxy) the vendor id 
	is 0x0EEF and product id is 0x0001.
	-	Launch Device Manager ( Control Panel -> System -> Devices)
	-	Expand the group “Mice and other pointing devices?
	-	Right-click the “USB Touchscreen Controller?(If this is not shown, right click the “HID-Compliant mouse?device, 
		repeating the operations for every “HID-Compliant mouse?displayed in this group until you find one with the 
		Vendor Id/ Product Id listed above).
	-	In the “Details?tab, select the “Hardware Ids?option and identify your touch panel by looking into the Vid and Pid values:
	-	For ACMEPOINT you should see the following text: VID\Vid_0eef&Pid_0001. For ITC you should see VID\Vid_1CB6&Pid_6680.

2nd Step ?Reinstall device driver package and recalibrate 
	-	Install the appropriate drier package by running the setup from your touch panel model folder
	-	Run the calibration utility:
		
		If you have the ACMEPOINT touch panel installed, launch its Configuration Utility 
		( Start->All Programs->Touch Kit->Configure Utility). Go to the “Tools?Tab and Press 
		the <Clear and Calibrate> button. Follow instructions to calibrate the panel according to marks.
 
		If you have the ITC touch panel installed, launch its setup utility (Start->All Programs->IdeaCom TSC->IdeaComTsc)
 		Press the <Calibration> button and follow the instructions to calibrate the touch panel.

3. After finishing driver installation, in All Program, find the driver's brand name.
If you see IdeaCOM, please run the BeepSetup\setup.exe as well. 
Please note you don't need to install this beep application under Win7, because NO beep sound under Win7.