Boot Loader Demo 2 An example to demonstrate the use of the Serial or Ethernet boot loader. After being started by the boot loader, the application will configure the UART and Ethernet controller, wait for the select button to be pressed, and then branch back to the boot loader to await the start of an update. The UART will always be configured at 115,200 baud and does not require the use of auto-bauding. The Ethernet controller will be configured for basic operation and enabled. Reprogramming using the Ethernet boot loader will require both the MAC and IP Addresses. The MAC address will be displayed at the bottom of the screen. Since a TCP/IP stack is not being used in this demo application, an IP address will need to be selected that will be on the same subnet as the PC that is being used to program the flash, but is not in conflict with any IP addresses already present on the network. Both the boot loader and the application must be placed into flash. Once the boot loader is in flash, it can be used to program the application into flash as well. Then, the boot loader can be used to replace the application with another. The boot_demo1 application can be used along with this application to easily demonstrate that the boot loader is actually updating the on-chip flash. ------------------------------------------------------------------------------- Copyright (c) 2007-2009 Texas Instruments Incorporated. All rights reserved. Software License Agreement Texas Instruments (TI) is supplying this software for use solely and exclusively on TI's microcontroller products. The software is owned by TI and/or its suppliers, and is protected under applicable copyright laws. You may not combine this software with "viral" open-source software in order to form a larger program. THIS SOFTWARE IS PROVIDED "AS IS" AND WITH ALL FAULTS. NO WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE. TI SHALL NOT, UNDER ANY CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, FOR ANY REASON WHATSOEVER. This is part of revision 5451 of the EK-LM3S8962 Firmware Package.Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.