Sil 3112 RAID Controller Adapter Silicon Image Tested and Approved with the following Novell products: NetWare® 6 NetWare® 6.5 Product Description Sil 3112 SataLink/Raid HAM, 2 Channel SATA, or built in Raid 0 or Raid 1. Primary Driver File(s) SI3112.HAM (19571 bytes 09-Mar-2004 09:05 pm v2.01d) Driver Support File(s) SI3112.DDI (19571 bytes 08-Mar-2004 09:01 am v2.14) Test Configuration Product Name Sil 3112 Hard Disk Drive 2 Silicon Image RAID 1 Set; 81.9 GB; Firmware 2.00; Serial ATA 150 (SATA150) Host Bus Adapter 2 Silicon Image Sil 3112A; PCI; BIOS 4.2.46; Channels 2; Chipset Sil 3112; Firmware SiI 3112; Serial ATA ; PCI.1095.3112.1095.6112.02; Version 1.21 System Intel® Vero Beach; Xeon(TM) CPU 2.40GHz ; BIOS Phoenix 4.0 Release 6.0 08/15/03; PCI-ISA; Memory 512 MB Configuration Note(s) The IDE/ATA interface does not support fault tolerance. Vero Beach requires MPS14.PSM Ver 3.00 April 11, 2003. The term Tested and Approved applies only to the exact configuration documented in this bulletin. For more information regarding the specific test configuration, please contact: Silicon Image 1060 E Arques Ave Sunnyvale, CA 94085Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.