1. PCN110.exe Driver
2. NCSA.TXT File Contents

NCSA.TXT Driver File Contents (PCN110.exe)

==================================================================
NOTES ON
Installing Maxtech PCN110 Fast Ethernet PC Card
For NCSA Users
==================================================================
    (c) 1998 Copyright Maxtech, ALL RIGHTS RESERVED



This document contains installation notes, which is not included in the
PCN110 Fast Ethernet PC Card USER'S GUIDE or onscreen instructions,
for NCSA users regarding PCN110 Fast Ethernet PC Card installation.


This document contains information on the following topics:

1.0 Introduction
2.0 Installing Pcaket driver
___________________________________________________________________



1.0 Introduction
----------------

NCSA users please also refer to the following:

    -------------------------------------------------------------------
     File                  Description/Installation notes
    -------------------------------------------------------------------
     \PKTDRV\README.TXT    For all Packet driver users



2.0 Installing Pcaket driver
------------------------------

    Here are the steps:

    1. To load a driver , use either of the following methods:

       METHOD 1:
          In your CONFIG.SYS file, include the DEVICE command.

               Format:
               DEVICE = PCN110PD.SYS [/option] <packet_int_no>


        METHOD 2:
          Issue PCN110PD command at the DOS command prompt.

               Format:
               PCN110PD.COM [/option] <packet_int_no>


    2. you need to install NCSA TCP/IP distributions into your
       computer. (Also refer to NCSA TCP/IP distributions \INSTALL
       for more information.)

    3. Please set correct values in CONFIG.TEL which is
       included in NCSA TCP/IP distributions as follows:

        CONFIG.TEL
        ----------
            :
            :
        hardware    = packet
        ioaddr      = <iobase>
        interrupt   = <irq>
            :
            :

        Please take note the above settings must be the same as
        driver's parameters.

    Now, the NCSA TCP/IP associated programs are ready to be used.



    Example:
    --------

    > PCN110PD.COM 0x62
    > EDIT CONFIG.TEL
                :
         hardware     = packet
         ioaddr       = <iobase>
         interrupt    = <irq>
                :
    > TELNET <IP_ADDRESS>