1. cdqt124.exe Driver
2. Readme.txt File Contents

Readme.txt Driver File Contents (cdqt124.exe)

	This is Firmware Ver.1.24 for UJDA110L-QT.
	This firmware resolves two symptoms: 1. A failure while 
	installing Windows95(JPN) OSR2. 2. The secondary IDE 
	controller on the Solo 2500 may have a yellow exclamation 
	point in Windows 98 Device Manager which results in the 
	CD-ROM not being recognized. 


	****To Update Firmware from Floppy Diskette: 
	
	1. Download the file CDQT124.EXE onto a bootable
	   floppy. 

	2. Execute the file CDQT124.EXE by typing "CDQT124.EXE" in Dos
	   or double clicking on the file in Windows

	3. The file will automatically extract the necessary 
	   firmware update files. 

	4. Restart the system with the floppy disk in the drive.  At the
	   A:\>  type the command to start the CD-ROM firmware upgrade.

	5. The following is the command needed to upgrade the 
	   firmware on a Solo 2500 only.
	

		LOAD128C /m QT124.DAT [Enter]

	6. Reboot the system only when it states to.

	7. Test the system while in Windows 98.
	
	If any complications occur please contact Gateway 
	Technical support.

	****To Update Firmware from File Saved on Hard Disk Drive:

	1.  Download the file CDQT124.EXE into a folder on your Hard Disk Drive.

	2.  Boot the system into Safe Mode Command Prompt Only.  This can be done by 
	    pressing the F8 key when the message "Starting Windows 98..." appears.

	3.  At the C:\> type "CDQT124.EXE" to extract the file

	4. The file will automatically extract the necessary 
	   firmware update files. 

	5. The following is the command needed to upgrade the 
	   firmware on a Solo 2500 only.

		LOAD128C /m QT124.DAT [Enter]
 
	6. Reboot the system only when it states to.

	7. Test the system while in Windows 98.

	If any complications occur please contact Gateway 
	Technical support.


********************
End README.TXT for CD-Rom
********************

Applicable Part Numbers:
3500419, 3500420, 3500421, 3500573, 3500618, 5500658, 5500830, 5500984