;;****************************************************************** ;;¹®±¸ Áß°£¿¡ ºóÁÙÀÌ ÀÖ´Â °æ¿ì -> space barÅ°ÀÔ·Â ÇÊ¿ä ;;¹®±¸ º° ±¸ºÐ ½Ã -> Enter (ºó Ä ÀÔ·Â ÀÖÀ¸¸é ¾È µÊ) ;;****************************************************************** ;;;;;Common;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [Button] OK= OK$ CANCEL= Cancel$ YES= Yes$ NO= No$ EXE= Run$ ERROR= Do not display this error message from the next diagnosis.$ ;;;;;DevInfoDll;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [DevInfoDll] DRIVE= No CD-ROM drive$ DRIVE_EX= No CD-ROM drive is installed in the system. Install a CD-ROM drive and try again.$ CD= Insert the System Software CD-ROM$ CD_EX_G= Insert the System Software CD-ROM and install the graphics driver. $ CD_EX_S= Insert the System Software CD-ROM and install the sound driver. $ CD_EX_N= Insert the System Software CD-ROM and install the network driver. $ ;;;;;FixCable;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixCable] TITLE= LAN Cable Detection$ EXPLAIN= For wired LAN connection, LAN cable has been detected unplugged. Please, make sure that the cable has been properly plugged in. For wireless LAN connection, wireless signal is weak or unreachable. Please, check whether your Access Point is up running.$ ;;;;;FixCpuVendor;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixCpuVendor] TITLE= Replace the CPU$ EXPLAIN= The CPU is an engineering sample. Replace the CPU by contacting the service center.$ ;;;;;FixDhcp;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixDhcp] TITLE= IP Settings$ EXPLAIN_TITLE= TCP/IP Properties$ EXPLAIN_EX= To use a static IP address, ask your network administrator about available IP addresses, select a network interface card and set up the IP address below.$ EXPLAIN_NET= Select a network interface card.$ EXPLAIN_DHCP= Click here to use an automatically allocated IP address.$ EXPLAIN_STATIC= Click here to use a static IP address.$ EXPLAIN_IP= IP Address$ EXPLAIN_SUB= Subnet Mask$ EXPLAIN_GATE= Default Gateway$ EXPLAIN_DNS= Preferred DNS Server$ NO_NETCARD= Select a network interface card.$ NO_IP= No IP address entered. Please check the settings and enter it again.$ NO_SUB= No Subnet Mask entered. Please check the settings and enter it again.$ NO_GATE= No Default Gateway address entered. Please check the settings and enter it again.$ NO_DNS= No DNS Server address entered. Please check the settings and enter it again.$ INVALID_ADDRESS= The address cannot start with 0 or 255.$ INVALID_MASK= The Subnet Mask starts with 255.$ ;;;;;FixDrv;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixDrv] TITLE= System Restart$ EXPLAIN= It is required to restart your system after installation has been complete. If you want to restart your system later, or to terminate all of the currently running programs, then click on 'Cancel'.$ ;;;;;FixGraphicResolution;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixGraphicResolution] TITLE= Done$ EXPLAIN= The resolution has been changed to 1024*768 pixels.$ ;;;;;FixHddVolume;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixHddVolume] TITLE= HDD access error$ EXPLAIN= Cannot read information on the hard disk drive normally. Contact the service center and check if the hard disk drive is out of order.$ ;;;;;FixLocal;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixLocal] TITLE= Problems detected in Local Network System.$ EXPLAIN= It is required to reset up Local Network properties. Internet Protocol(TCP/IP) is not properly set up.$ ;;;;;FixNorton;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixNorton] TITLE= Norton AntiVirus not installed$ EXPLAIN= Norton AntiVirus not installed. It is recommended installing Norton AntiVirus included on the Software media to cure viruses.$ ;;;;;FixNortonAutoProtection;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixNortonAutoProtection] TITLE= Auto Protect Disabled$ EXPLAIN= The Auto Protect function of Norton AntiVirus is disabled. It is recommended setting the Auto Protect function to protect the system. To run Norton AntiVirus, click the Run button.$ ;;;;;FixPing;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixPing] TITLE= Network Environment Error$ EXPLAIN= Cannot connect to the Internet. Contact your Internet connection service provider.$ ;;;;;FixVMSize;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;; [FixVMSize] TITLE_PASS= Done$ EXPLAIN_PASS= The changes in the size of Virtual Memory will be applied after system reboot.$ TITLE_FAIL= Disk out of space$ EXPLAIN_FAIL= Failed to optimize setting Virtual Memory because of the lack(shortabe) of Hard Disk Space. Please, try again after running fragmentation.$Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.