1. 1207D-110.zip Driver
2. SCOUNIX.TXT File Contents

SCOUNIX.TXT Driver File Contents (1207D-110.zip)

*******************************************************************
*                  ACCTON TECHNOLOGY CORPORATION                  *
*        EN1207D/EN2242A SERIES PCI FAST ETHERNET ADAPTER         *
*                      SCO UNIX STREAM DRIVER                     *
*                                                                 *
*         Copyright (C) 2001 Accton Technology Corporation        *
*                       All Rights Reserved.                      *
*******************************************************************

The unix driver contained in the directory \SCO is for the
following PCI Ethernet adapter:

        Accton EN1207D/EN2242A Series PCI Fast Ethernet Adapter

  Contents:
  ---------

        A.) Installing MDI Unix Driver for SCO ODT 5.0
        B.) Installing LLI Unix Driver for SCO 3.2.4 (ODT 3.0)


File Description
================

5.X\            SCO ODT 5.0 MDI Unix Driver

SCOUNIX.TXT     this file


A.) Installing MDI Unix Driver for SCO ODT 5.0
==============================================

1. Log into the UNIX system as supervisor (root) and enter Maintenance mode.

    (Note: Make sure that the current directory is "/"
     using UNIX command - pwd.)

   Please follow the following steps to uncompress the package file:

   >  cd /tmp   (and insert the floppy in the proper drive, i.e. a:)
   >  doscp a:/sco/5.x/vol.000 ./VOL.000.000

   Now the installation directory is ready for use.

3. The following sections describe configuration of the driver.
   It is suggested that you should carry out these instructions in a
   singler-user environment.

   Run the custom utility and select the "Install new package" option.

   Select Media Type "Media Image" and type Image Directory "/tmp "
   It will prompt with "Accton EN1207D-TX PCI Fast Ethernet Adapter
   (ver 1.0.2)"

   After running the custom utility and the new package is installed,
   you should use the "netconfig" command to add the driver into your
   system as described in step 4 below.

4. Run "netconfig". Add the desired chain.

5. When the chain has been configured, select 'q' from the
   netconfig menu. and relink the kernel at the prompt.

6. To activate the adapter, you must reboot. When the system
   boots, you should see the following data dispalyed among the
   configuration messages:

    %ethernet  0xD800-0xD81F   11   -   type=100 addr=00-00-e8-xx-xx-xx
                               .
                               .
                               .
     auto mode
     choice is auto negotiation mode
     Speed is 100 Mbps

   with the appropriate I/O addresses, IRQ, Adapter Type ,IEEE address and
   medium mode (auto,100full,100half,10full,10half).
   The display of the last three bytes of the IEEE address depends on the
   adapter currently plugged into your system.

7. If you encounter any problems during installation,
   (i.e., an error message appears on screen) call your dealer for assistance.



B. Installing LLI Unix Driver for SCO 3.2.4 (ODT 3.0)
======================================================
   You can get the SCO ODT 3.0 LLI driver from Accton web site,
   http://www.acctontech.com
   after you get the driver, please follow up the installation guide
   in the related readme file to complete the driver installation.


TRADEMARKS
==========

All Tademarks or Brand names mentioned are properties of
their respective companies.

== End of File ==