1. SN2000.exe Driver
2. NCSA.TXT File Contents

NCSA.TXT Driver File Contents (SN2000.exe)

Ether Support Publishing      \PKTDRV\NCSA.TXT

           Ether SN2000 Ethernet Adapter Packet Driver Installation
                   for NCSA

 Getting Started
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
    The First Step :

    Loading driver via two methods :

    METHOD 1:
    ÄÄÄÄÄÄÄÄ
     If the SN2000.SYS program is used, the following statement must be
      included in your CONFIG.SYS file:

       DEVICE = SN2000.SYS [/option] <packet_int_no>

      See \PKTDRV\README.TXT for addition parameters

      You can place this line anywhere in the CONFIG.SYS file.

    METHOD 2:
    ÄÄÄÄÄÄÄÄÄ
     If the SN2000.COM program is used, follow these steps:

     Execute SN2000.COM by typing:

          >SN2000 [/option] <packet_int_no>

      See \PKTDRV\README.TXT for addition parameters

    The Secondry Step:

     First, you need to install NCSA TCP/IP distributions into your machines.

      See also NCSA TCP/IP distributions \INSTALL for detail informations

     Please set correct values in CONFIG.TEL which is included in NCSA
      TCP/IP distributions as followings:

      in CONFIG.TEL
            :
            :
         hardware    = packet
         ioaddr      = <iobase>
         interrupt   = <irq>
            :
            :

      These values must the same as driver's parameters.

     NCSA TCP/IP associated programs are ready to used

      See also NCSA TCP/IP distributions \INSTALL for detail informations

    Examples:

      > SN2000.COM 0x62

      > EDIT CONFIG.TEL
            :
        hardware     = packet
        ioaddr       = 300
        interrupt    = 5
            :

      > TELNET <IP_ADDRESS>