1. JACKSON2.EXE Driver
2. NWDOSODI.TXT File Contents

NWDOSODI.TXT Driver File Contents (JACKSON2.EXE)

NWDOSODI.TXT file
3Com Corporation
3Com Megahertz LAN + Modem PC Card (3CxEM556 PC Card family)
Network Drivers Installation Notes


              WINDOWS 3.1X AND NOVELL NETWARE

 This document describes how to configure the LAN+Modem card
 for use with Windows version 3.1x and Novell NetWare. These
 procedures are also described in the LAN+Modem card User
 Guide.

 NOTE: The following instructions assume you have not installed
       another network adapter in the PC. If another networking
       adapter has already been installed, these instructions will
       not apply or appear accurate. Consult with your MIS 
       department or System Administer for further instructions.

 Before installing the network driver, you should know the 
 transport used in the Novell Network (typically IPX/SPX) and
 have access to the following software components:

    - Novell NetWare VLM Client disks for DOS and Windows
    - The Installation Disk #2 that came with your LAN+Modem card.


 Installation Instructions
 -------------------------

 1.  Boot the PC in DOS. If the PC starts up in Windows,
     exit Windows to return to the DOS prompt. 

 2.  Place the Novell VLM client disk #1 in the floppy drive. Type:

         a:\install <Enter>.

     This opens the NetWare client installation screen.

 3.  Use the down arrow key to move from line to line. Make sure 
     that all information is correct. When you are asked to select
     the driver for your network card, click "Enter" to see the
     list of supported adapters. At the bottom of the list, 
     select "Other Drivers".

 4.  When prompted for a driver disk, put the Installation 
     Disk #2 in your floppy drive and press Enter. The LAN+Modem 
     card should appear as the first item on the list. Select it 
     and click "Enter".

 5.  Specify the frame type by clicking "Enter" and choosing the
     appropriate type from the list. Click "Enter" to select your
     choice. 

     (You will not need to select an I/O Base. Use the default.)

 6.  Press F10 to return to the main installation screen. Position
     the cursor on line 6 and press Enter. The installer
     prompts you for several diskettes and notifies you when the
     installation is complete.

 7.  Click "Enter" to exit the installation program and return to DOS.

 8.  Reboot the computer by clicking <CTRL><ALT><DEL>. When you 
     go into Windows You will be able to LOGIN to the 
     Novell Servers.

 The configuration manager (EMENABLE.EXE) must be added to the 
 AUTOEXEC.BAT file or CONFIG.SYS file. Add the line:

         EMENABLE

 Specify a directory path if required.

(%VER NWDOSODI.TXT v5.56.0)