Use the DOS version of SASFlash.EXE to update the firmware and BIOS for the LSI SAS HBAs. If the HBA has firmware older than 1.22.01 you must boot to DOS in order to upgrade the firmware. To update the firmware and BIOS in the same command line use the following. sasflash -f <firmware_name>.fw -b <BIOS_name>.ROM The following steps demonstrate the use of the batch file included in the firmware package. To flash a SAS HBA follow the following steps 1) Make a bootable DOS disk (either floppy or USB) 2) If using floppy disks, prepare a second blank floppy to extract the contents of the download zip onto. The files in the download zip file will not fit on the boot diskette. 3) Down load the firmware files from the web site for the appropriate HBA 4) Extract the files from the .zip for the board you are updating to the bootable disk. 5) Boot the system where the HBA is installed with the bootable disk 6) Run the HBAFlash.bat batch fileDownload Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.