Use the DOS version of SASFlash.EXE to update the firmware and BIOS for the LSI SAS HBAs. If the HBA has firmware older than 1.22.01 you must boot to DOS in order to upgrade the firmware. To update the firmware and BIOS in the same command line use the following. sasflash -f <firmware_name>.fw -b <BIOS_name>.ROM The following steps demonstrate the use of the batch file included in the firmware package. 1) Make a bootable DOS disk (either floppy or USB) 2) If using floppy disks, prepare a second blank floppy to extract the contents of the download zip onto. The files in the download zip file will not fit on the boot diskette. 3) Down load the firmware files from the web site for the appropriate HBA http://www.lsi.com/cm/DownloadSearch.do?locale=EN , select your BOARD, select 4) Extract the files from the .zip for the board you are updating to the bootable disk. example SAS3442X.zip 5) Boot the system where the HBA is installed with the bootable DOS disk 6) Run the hbaFlash.bat utility 7) Follow the instructions. You must decide which type of firmware you want to install: - Integrated RAID (IR) or - Initiator-Target (IT) You must also supply the chip version, which will be displayed on screen. See the example below. Welcome to LSI Logic Integrated SAS Flash Utility This Utility will upgrade your LSI SAS3442E HBA Integrated RAID ( IR ) or Initiator ( IT ) Firmware For IR Type R or r For IT Type T or t To Exit Type q Enter R, T or q **************************************************************************** LSI Logic Corp. SAS FLASH Utility. SASFlash Version 1.03.07.00 (2007.01.30) Copyright (c) 2006 LSI Logic Corporation. All rights reserved. **************************************************************************** Adapter Selected is a LSI SAS 1068E(B2) Num Controller FW Ver NV Ver BIOS Ver PCI Addr ------------------------------------------------------------------------------------------------------ 1 1068E(B2) 01.18.00.00 25.0b 06.12.00.00 01:00:00 Finished Processing Commands Successfully. Exiting SASFlash The above shows which chip is on the HBA For 1068E(B1) Type 1 For 1068E(B2) Type 2 To Exit Type q Enter 1, 2 or q You have selected 3442E IR firmware with chip B1 To Flash Type F or f To Exit Type Q or q Enter F or Q sasflash -f 3442ERB1.fw -b MPTSAS.ROMDownload Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.