*******************************************************************
Upgrading to version 12.04.0045 firmware for Tripp Lite SNMPWEBCARD
*******************************************************************
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!WARNING:ALL EVENT AND CONTACT SETTINGS ON THE SNMPWEBCARD AND EVENT LOG !
! INFORMATION WILL BE LOST UPON UPGRADE !
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
_________________________
UPGRADING VIA FTP SESSION
_________________________
The steps involved in upgrading the SNMPWEBCARD requires multiple FTP sessions to
upload two images and a protocol file. The steps are as follows:
1) Initiate an FTP session with the SNMPWEBCARD from the file4step1 folder
2) Login
3) Type "bin"
4) Type "put rom.bin" to upload the file located in the file4step1 folder
5) Type "bye"
6) The card will reboot
7) While the card is rebooting change to the files4step2 directory
8) After about 2-5 (depending if HTTPS is enabled) minutes the card should
be available again
9) Initiate an FTP session with the SNMPWEBCARD
10) Login
11) Type "bin"
12) Type "put rom.bin" to upload the file located in the file4step2
13) When the upload is complete type "put pwralert.dat"
14) Type "bye"
15) The card will reboot
16) After about 2-5 minutes the SNMPWEBCARD should be back on-line
17) Login through HTTP or Telnet to configure the lost settings for the card
18) If multiple cards need to will be upgraded and require re-configured after
the firmware has been upgrade it is possible to retrieve a configuration file
through the web browswer the upgraded and reconfigured card above.
19) To retrieve configuration file, connect to the IP address of the SNMPWEBCARD
just configured and go to Settings-System menu and click the 'write' button on
the bottom of the screen
20) Wait a minute, then click the 'view' button
21) Enter the admin password
22) When the message to open or save appears select save and save the
paconfig.ini file to a directory
23) This file can the be uploaded to other SNMPWEBCARDS after steps 1-16
have been completed for each applicable card
24) To upload the paconfig.ini, FTP to the IP address of the card to
be configured
25) Login
26) Type "bin"
27) Type "put paconfig.ini"
28) Type "bye"
29) The card will reboot and read in the setting from the paconfig.ini
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.