1. ep10759.exe Driver
2. README.TXT File Contents

README.TXT Driver File Contents (ep10759.exe)

********************************************************************
README file for EPSON Generic 9Pin With Euro for Windows(R) 3.1/
Windows(R) 95/Windows(R) 98/Windows NT(R) 3.50 /Windows NT(R) 3.51
Windows NT(R) 4.0
********************************************************************

This README file has the following sections:

A. Instructions for the EPSON Generic 9Pin With Euro Driver
B. How to install
C. General Notices

A. Instructions for the EPSON Generic 9Pin With Euro Driver
=============================================================

This printer driver supports printing with EPSON 9Pin single impact dot 
matrix printers (SIDMs) using built-in fonts. In addition, the printer 
driver also supports Euro Symbol printing.
The driver supports Euro Symbol printing with the FX-880 and later 
models. To print Euro Symbols with the LX-300, FX-870, FX-1170, FX-2170, 
and DFX-5000+ printers, please contact your local EPSON service center 
for information on updating your printer's ROM. 
If your printer is not among those listed above, then the built-in fonts 
cannot print Euro Symbols. 

B. How to install
==================
To install in Windows(R) 98 / Windows(R) 95 / Windows NT(R) 4.0
1. Double-click the "My Computer" icon.
2. Right click on the FD icon and select "open".
3. Double-click the "Setup.exe" icon.

To install in Windows(R) 3.1 / Windows NT(R) 3.50 / Windows NT(R) 3.51
1. From the File menu, select Run.
2. Type " A:\Setup.exe " and click OK.
(If the Floppy Disk drive you are using is not drive A, substitute the 
correct letter.)

C. General Notices
===================
1.  Setting the loading position
The driver automatically sets top and bottom margins as follows:
Manual Feed/ Cut Sheet Feeder : 4.2mm
Tractor (Continuous Paper) : 0mm
The driver does not support top and bottom margin adjustments. If you want 
to change the printer margins, please do so with either the printer control 
panel, or in your application. Please be sure not to print outside the 
printable areas. Doing so may cause problems.
  
2.  User-defined sizing
For Windows 3.1 users:
If using a user-defined size, set the page length in the printer's control panel 
before printing.

For Windows NT(R) 3.50/Windows NT(R) 3.51 users:
If using a user-defined size, use the driver only with the Portrait orientation 
as the Landscape setting affects the page length. To print in the Landscape 
orientation, be sure to set the page length in the printer control panel before 
you print.

3.   Using the proportional size in built-in fonts
This printer driver supports printing with EPSON 9Pin single impact dot 
matrix printers (SIDMs) using  built-in fonts. 
But the LX series printers cannot print the proportional size font.