This document contains instructions for installing the IBM 1x16 Autoloader(tm)
driver for Windows 2000 Intel platforms. This driver is for 32-bit Intel Platforms only.
MAKING AN INSTALLATION DISKETTE:
After running the executable file, there will be 3 files extracted
to the directory. These are:
Qtmmc.inf
Qtmmc.sys
ReadMe.txt (this file)
To make the Installation Diskette, copy the following 2 files to
a formatted 3 1/2 inch floppy disk.
Qtmmc.inf
Qtmmc.sys
INSTALLING THE DRIVER:
1. Shutdown Windows if it is running and power down the system.
2. Connect the IBM 1x16 Autoloader to the system. Ensure that the
SCSI bus is terminated correctly and that there are no target
ID conflicts. Power on the autoloader.
3. Startup the system and log into Windows.
4. Right-click on the "My Computer" Icon and select "Manage".
This will bring up the Computer Management applet.
5. In Computer Management, double-click "Device Manager".
A list of device subsystems will be displayed in the right view.
6. The target autoloader may be found in the "Medium Changers"
section. Expand the section where the
target autoloader is located. Right-click the target "Uknown Medium Changer"
and select "Properties".
NOTE: Troubleshooting the SCSI bus that the target autoloader
is attached to will be necessary if Windows 2000 does not
see the autoloader in the "Medium Changers" section.
Do not continue installation until this is resolved.
7. In the Properties window, verify that the SCSI ID matches
that of the autoloader that you are installing.
8. Select the "Driver" tab and then select "Update Driver...".
This will start the "Upgrade Device Driver" Wizard.
9. In the Device Wizard, select "Next".
10. Select "Display a list of the known drivers for this device so
that I can choose a specific driver" radio button.
11. Select "Next".
13. Insert the floppy disk into the floppy drive. Make sure
that the path name to the drive is correct.
14. Click "OK".
15. Highlight the listed IBM 1x16 Autoloader driver and then click
"Next".
16. The "Start Device Driver Installation" view is displayed.
17. Click "Next" to install the driver.
a. Should the Wizard indicate that the driver already exists on
the system and prompts you for a selection, select "New".
b. The Windows 2000 Setup window is displayed. Verify the
correct path to the driver, then select "Continue".
18. The next view is "Completing the Upgrade Driver Wizard". Click
"Finish". You may be prompted to reboot your system.
19. The IBM 1x16 Autoloader driver is installed.
If you have problems, questions or feedback relating to the installation or
usage of this driver please contact Quantum technical support at:
dlt.driver@qntm.com
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.