1. SMC2632Wv2_DRUT.exe Driver
2. README File Contents

README Driver File Contents (SMC2632Wv2_DRUT.exe)

*********************************************************
***           SMC WLan PC Card 11Mbps               ***
***              Linux Device Driver                  ***
*********************************************************

1. Install driver
   a)  untar the package using the command:
       ---> tar zxvf SMC_PCMCIA_WIRELESS_2632W-V2.tar.gz
   b)  cd SMC_PCMCIA_WIRELESS_2632W-V2
   c) ./setup.sh

2. Support 
   a)  Support RedHat 7.1, Redhat 7.2, Redhat 7.3
   b)  linux-kernel 2.4.17, 2.4.18

3. Module Parameters
--------------------
   You can configure the ATMEL 11Mbps PC Card by editing
   the config.opts located in the /etc/pcmcia directory.
   Change the parameters, whose default values aren't 
   those you want.

   i.e. if you want to connect to an access point named 
   WLAN just add in config.opts the following line
        module "fvnetr_cs" opts "ESSID=WLAN"

*********************************************************
***                 IMPORTANT NOTICE                  ***
*** Whenever you change any parameter in config.opts  ***
***   you must restart the pcmcia card services by    ***
***                      running :                    ***
***         /etc/rc.d/init.d/pcmcia restart           ***
*********************************************************

   The Parameters you can change and their default values 
   are:

   channel     :  1 - 14
      (default = 3)

   TxRate      :  0 ->   1Mbps
            	  1 ->   2Mbps
		  2 -> 5.5Mbps
		  3 ->  11Mbps
		  4 ->    Auto
      (default = 3 (11Mbps) )
	
   RTSThreshold :   1 - 2347
      (default = 2347)

   FragThreshold: 256 - 2346
      (default = 2346)

   OpMode       : 1 -> Ad-Hoc
	          2 -> Infrastructure
      (default = 2)

   ESSID	: ESSID to use (max 32 characters)
      (default = ANY)

   EncryptionLevel : 0 -> disable
   		     1 -> 64-bits	

   WepKeyToUse  : 0 -> WepKey1
	          1 -> WepKey2
		  2 -> WepKey3
		  3 -> WepKey4
		  4 -> None
		  (default = 4 (None) )			

   WepKey1      : maximum 5 bytes (must always be 2 characters/byte)
	
   WepKey2      : maximum 5 bytes (must always be 2 characters/byte)

   WepKey3      : maximum 5 bytes (must always be 2 characters/byte)

   WepKey4      : maximum 5 bytes (must always be 2 characters/byte)
      All WepKey's  are zero by default.

   WepMode      : 0 -> Mandatory
	          1 -> Optional
      (default = 0 (Mandatory) )

   AuthenticationType : 0 -> Open System
	                1 -> Shared Key
      (default = 0 (Open System) )
   PreambleType	   : 0 -> Long Preamble
	             1 -> Short Preamble
      (default = 0 (Long Preamble) )
      (In infrastructure mode PreambleType is autodetected).

   PwrMgmtMode	: 0 -> Active
	          1 -> Power Save
      (default = 0 (Active) )