1. Pp60826.zip Driver
2. LANTAST5.TXT File Contents

LANTAST5.TXT Driver File Contents (Pp60826.zip)

	 ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ»
	 º                                                   º
	 º Compex ParaPort2 Pocket Ethernet Network Adapters º
	 º   Copyright (C) PDS, 1996. All Rights Reserved.   º
	 º                                                   º
	 ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ


1) INSTALLATION

   This document describes the procedures for installing
   NDIS2 driver for LANtastic 5.0 in Windows For Workgroups 3.11 
   and DOS.

1.1) LANtastic 5.0 with Windows For Workgroups 3.11

1.1.1) Setup

     a) Start Windows For Workgroups 3.11 and install a
     network adapter. Please refer to Windows For Workgroups
     3.11 User Guide for the installation procedures of
     a network adapter.

     b) Start Windows For Workgroups 3.11 again.

     c) Insert LANtastic Network Software v5.0 Disk 1 into
     drive A.

     d) In File Manager, run INSTALL.EXE in the Disk 1.

     e) Enter an UNIQUE computer name in the Enter Computer Name
     box.

     f) Select the destination drive in the Enter Target Drive
     box.

     g) Enter the destination directory in the Enter Directory
     box.

	eg. C:\LANTASTI

     h) Select the additional LANtastic features in the
     Select All That Apply box.

     i) Select the NDIS Support for Network Adapters option
     in the Select Network Adapter box.

     j) Enter the full pathname for the directory containing the
     NDIS 2.01 driver in the Enter NDIS Driver Directory.

	eg. A:\NDIS2

     k) Insert Adapter Disk into the floppy drive (eg. A:)

     m) Follow the instructions to continue the installation.

1.1.2) Extra Modifications for NDIS Driver Installation

     If you install the client to Microsoft network ONLY, a NDIS
     driver is required. Follow the instructions here to make some
     modifications.

     a) Use any text editor to open the setup file,
     PROTOCOL.INI in your LANtastic home directory
     (eg. C:\LANTASTI) and modify it as follows.

	...
	[NETBEUI_XIF]
	Drivername = NETBEUI$   <- Add this line
	...

     b) If the hardware settings of the adapter are different
     from that specified in the PROTOCOL.INI, please change them
     correctly.

     c) Obtain the file, NETBEUI.EXE, from Microsoft and copy it
     to your LANtastic home directory (eg. C:\LANTASTI).

1.2) LANtastic 5.0 with DOS

     a) Insert the Disk 1 and execute the following command.

	A:\>INSTALL /DOS

     b) Enter an UNIQUE name in the Enter Computer Name box.

     c) Select the destination drive.

     d) Enter the destination directory in the Enter Directory box.

     e) Select the correct LANtastic features.

     f) Check the installation information.

     g) Modify the files as described in the section (1.1.1) or
     (1.1.2) accordingly.