3Com Corporation
EtherDisk Diskette for
the Fast EtherLink and the EtherLink III (R) Bus Master Adapters
Troubleshooting
If the adapter diagnostic tests fail, the adapter might not be defective.
Check the following:
1. Make sure that the adapter is completely seated in its slot. Review
the installation instructions in the appropriate adapter guide.
2. If you are running the Group 2 test, make sure that the adapter is
securely connected to a loopback plug or to a properly cabled network.
3. If you are running the Group 3 test, make sure that the adapter is
securely connected to a properly cabled network and an echo server is
set up on the network.
4. Make sure that the configuration setting for the transceiver type is
correct.
5. Running Group 2 tests while connected to an active network can cause
intermittent failures. These failures can be avoided by using a
loopback plug or by connecting to an inactive network on which only
the computer being tested is operating.
6. If you installed a twisted-pair adapter, check the LED on the
backplate of the adapter. The LED should be checked only during or
after the diagnostic tests have been run. The LED will be on when
there is a correct connection between the adapter and the hub. The
LED will flash if the polarity of the connection is swapped.
7. The slot in the computer may be defective. Install the adapter in
another slot and run the tests again.
8. The computer in which the adapter is installed might be defective.
Install the adapter in a known functioning computer and run the tests
again.
9. The loopback plug you are using might be defective. Try a different
loopback plug.
10. Replace the failed adapter with a known working adapter, with the same
configuration. If the second adapter fails, something is probably
wrong with the test environment, not with the adapter.
(%VER Troubleshooting v1.0b)
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.