*****************************************************************************
* *
* Microsoft Windows for Workgroup 3.11 Installation *
* for Grey Cell System 3400 Series Fax/Modem/Ethernet Card *
* *
*****************************************************************************
Installation Procedures:
USING NE2000 DRIVER (Must Use CARD2.EXE or CARD2CS.EXE)
OR
USING DRIVER WITH ENABLER GCS3000.DOS
NOTE: WITH GCS3000.DOS RUN ASK-RSC IN DOS TO ASSERTAIN FREE RESOURCES.
USING NE2000
------------
(1) Make sure your 3400 series PC card has been enabled either by
CARD2CS.EXE for PCMCIA card and socket services, or by
CARD2.EXE for DOS with no card and socket services.
(2) Reboot the PC with the 3400 series Card in the PCMCIA slot
NE2000 & DRIVER/ENABLER
------------------------
(3) Start Microsoft Windows
(4) Select "Network Setup" from Program Group "Network"
(5) Select "Drivers..."
(6) Select "Add Adapter..."
(7) Select "Unlisted or Updated Network Adapter"
(8) Type in the path name A:\WFW311 and insert 3400 Series Installation
Disk into drive A:
USING NE2000
------------
(9) Select the Grey Cell 3400 Fax/Modem/Ethernet Card (NE2000 Mode)
(10) Setup the correct interrupt (IRQ) number and base I/O port address,
this should match CARD2 or CARD2CS parameters.
The translation table for COM port to interrupt number is listed below:
COM2 -> IRQ 3
COM3 -> IRQ 4
COM4 -> IRQ 3
When you OK this setting you will probably get a warning dialog box
saying that Interrupt x is associated with COMy. etc.
Finally you are asked "Do you wish to select a different setting?"
Select NO.
(11) Goto Step 12
USING GCS3000.DOS
-----------------
(9a) Select the Grey Cell 3400 Fax/Modem/Ethernet Card (w/Enabler)
(10a) Setup the interrupt (IRQ) number and base I/O port address.
NOTE: This should not match the IRQ of the COM Port listed below:
COM1 -> IRQ 4
COM2 -> IRQ 3
COM3 -> IRQ 4
COM4 -> IRQ 3
(11a) Then Select Advanced, and select the COM Port Required.
(12) Setup the correct networking support for Windows and file/printer
sharing options.
(11) Restart the PC.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.