1. tepcipb.exe Driver
2. README.TXT File Contents

README.TXT Driver File Contents (tepcipb.exe)

           TRENDware TE-PCI/TE-100PCI Ethernet Adapter Installation
                   for Windows NT V4.0

 Contents
 ÄÄÄÄÄÄÄÄ
     Introduction
     Requirements
     Minimum Skill Level
     Compatibility List
     Getting Started

 Introduction
 ÄÄÄÄÄÄÄÄÄÄÄÄ
    This installation assumes that the adapter is working properly.
    Getting Started will describe the installation instructions.

 Requirements
 ÄÄÄÄÄÄÄÄÄÄÄÄ
     A PCI compatible computer
     Windows NT V4.0
     A PCI Family Series Adapter
     A knowledge of basic DOS commands and editing text files

 Minimum Skill Level
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
     A knowledge of basic DOS commands
     A knowledge of editing text files
     A knowledge of DOS basic file structure (CONFIG.SYS and AUTOEXEC.BAT)
     A knowledge of the network driver configuration being used

 Compatibility List
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
     Any PCI Family Ethernet Adapter
     For a Motherboard compatibility list please consult your local
      Branch Office

 Getting Started
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

     Start your Windows NT 4.0 PC normally and inserting the network
      adapter into your computer.

     Open "My Computer" -> "Control Panel" -> "Network" icons.

     Select "Adapters" -> "Add" -> "Have Disk" items.
      Type the following (assume the driver is located at C:\NT40)

            C:\NT40

      Select the correct driver according to your adapter type.

     Windows NT 4.0 will copy the driver files from the driver disk.
      It also will pop up the configuration window, you can assign the
      "Connection Type" and "Network Address" here.

     After finishing file copy, Windows NT 4.0 will ask you to reboot the PC.
      Select YES.

     Restart the computer.


    Driver keywords:
    ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

     Open "My Computer" -> "Control Pannel" -> "Network" ->
      Double click "TE-100PCI Fast Ethernet PCI Adapter ... "

      Connection Type      Specify the connection type for the adapter.
                           Default: AutoSense

      Network Address      You can set the Ethernet address for your adapter.
                           It is not recommended to use this keyword. Please
                           use default value if possible.
                           As you know two or more adapter in the same network
                           with same Ethernet address will cause a little
                           poblem.

                           When using this keyword you need to input exactly
                           6 bytes of Ethernet address using one of the
                           following format:

                             xx-xx-xx-xx-xx-xx
                           OR
                             xxxxxxxxxxxx

                           Default: read address from adapter ROM.