8139/TXT/NETWARE/NWODIOS2.TXT Driver File Contents (mb_5CDriver_5CLAN_5CRealtek_5C8100C_8110S_5C649_642.zip)
Driver Package File Name: mb_5CDriver_5CLAN_5CRealtek_5C8100C_8110S_5C649_642.zip
Workstation for OS2 ODI Client
This document describes the procedure to setup the NetWare v3.X , v4.X
OS2 workstation driver for REALTEK RTL8139 Plug&Play ethernet adapter.
Location of Driver: \NWCLIENT\OS2\RTSOS2.SYS
Sample Configuration Files:
DEVICE=C:\NETWARE\LSL.SYS ; OS/2 Requester supported
DEVICE=C:\NETWARE\DDAEMON.SYS ; OS/2 Requester supported
DEVICE=C:\NETWARE\RTSOS2.SYS ; REALTEK supported
DEVICE=C:\NETWARE\IPX.SYS ; OS/2 Requester supported
LINK DRIVER RTSOS2
Installation Procedure :
Before you start with the installation procedure, make sure that the
dadapter is properly installed and configured. Similarly, Make sure
that your NetWare Requester for OS/2 is properly installed.
Please refer to "Novell NetWare Requester for OS/2" documentation for
a detailed Requester and Utilities installation guide.
1. Copy the RTSOS2.SYS file into the NETWARE subdirectory of your
hard disk from the Realtek Driver Diskette A:\NWCLIENT\OS2.
2. Add or replace the RTSOS2.SYS in the CONFIG.SYS file.
3. Edit the NET.CFG file that you copied over. Edit the file per your
requirements (see examples above). If there are two frame types
listed, whichever frame type is listed first, that is the one that
the driver will load. See above for examples.
4. Reboot your system to get service of network.
You can bind several frame types to the IPX protocol to support
various configurations. Include this in the Link Driver RTSOS2
section of the NET.CFG file. A sample is shown below:
Link Driver RTSOS2